Share Email Print

Proceedings Paper

An uncooled microbolometer focal plane array using heating based resistance nonuniformity compensation
Author(s): Murat Tepegoz; Alp Oguz; Alperen Toprak; S. Ufuk Senveli; Eren Canga; M. Yusuf Tanrikulu; Tayfun Akin
Format Member Price Non-Member Price
PDF $17.00 $21.00

Paper Abstract

This paper presents the performance evaluation of a unique method called heating based resistance nonuniformity compensation (HB-RNUC). The HB-RNUC method utilizes a configurable bias heating duration for each pixel in order to minimize the readout integrated circuit (ROIC) output voltage distribution range. The outputs of each individual pixel in a resistive type microbolometer differ from each other by a certain amount due to the resistance non-uniformity throughout the focal plane array (FPA), which is an inevitable result of the microfabrication process. This output distribution consumes a considerable portion of the available voltage headroom of the ROIC unless compensated properly. The conventional compensation method is using on-chip DACs to apply specific bias voltages to each pixel such that the output distribution is confined around a certain point. However, on-chip DACs typically occupy large silicon area, increase the output noise, and consume high power. The HB-RNUC method proposes modifying the resistances of the pixels instead of the bias voltages, and this task can be accomplished by very simple circuit blocks. The simplicity of the required blocks allows utilizing a low power, low noise, and high resolution resistance nonuniformity compensation operation. A 9-bit HB-RNUC structure has been designed, fabricated, and tested on a 384x288 microbolometer FPA ROIC on which 35μm pixel size detectors are monolithically implemented, in order to evaluate its performance. The compensation operation reduces the standard deviation of the ROIC output distribution from 470 mV to 9 mV under the same readout gain and bias settings. The analog heating channels of the HB-RNUC block dissipate around 4.1 mW electrical power in this condition, and the increase in the output noise due to these blocks is lower than 10%.

Paper Details

Date Published: 31 May 2012
PDF: 10 pages
Proc. SPIE 8353, Infrared Technology and Applications XXXVIII, 83531E (31 May 2012); doi: 10.1117/12.964525
Show Author Affiliations
Murat Tepegoz, Middle East Technical Univ. (Turkey)
Alp Oguz, Middle East Technical Univ. (Turkey)
Alperen Toprak, Middle East Technical Univ. (Turkey)
S. Ufuk Senveli, Middle East Technical Univ. (Turkey)
Eren Canga, Middle East Technical Univ. (Turkey)
M. Yusuf Tanrikulu, Middle East Technical Univ. (Turkey)
Tayfun Akin, Middle East Technical Univ. (Turkey)

Published in SPIE Proceedings Vol. 8353:
Infrared Technology and Applications XXXVIII
Bjørn F. Andresen; Gabor F. Fulop; Paul R. Norton, Editor(s)

© SPIE. Terms of Use
Back to Top