Share Email Print

Proceedings Paper

Optical And Mechanical Properties Of The Zinc Chromate Absorbing Selective Surfaces
Author(s): Alia H. Musa; F. Y. M. Al-Shaikley
Format Member Price Non-Member Price
PDF $17.00 $21.00

Paper Abstract

Selectively absorbing coatings were prepared on zinc electroplated-steel substrates by chromate conversion method after addition of either AgNO3 or CuSO4.5H20 to the chromate bath supplied by Electrical Industry Company (EIC) in Baghdad, Iraq. The values of the absorptance, ∝, integrated over the solar spectrum and emittance, ε, integrated over the blackbody, radiation at 100°C were calculated from the measured reflectance values for various times an at different concentration of AgN03 of conversion. The results indicate that addition 0.2 g/l of either AgNO3 or CuSO4.5H2O to EIC bath resulted in an absorbing selective coatings with ∝ = 0.88 and ε(100°C) = 0.16 for an immersion time of 25 sec (surface 1) and with ∝= 0.85 and 6 (100°C) = 0.10 for an immersion time of 20 sec respectively. Both surfaces shower a little decrease in total absorptance with increasing angle of incidence. The surface analysis (SEM, EDXA) showed cracks of the coatings on surfaces 1 and 2 and the main constituents were zinc and chromium. However, the Zn/Cr ratio was greater for the former. Finally mechanical properties, thermal stability, humidity and outdoor field tests were also carried out for both surfaces.

Paper Details

Date Published: 6 March 1989
PDF: 8 pages
Proc. SPIE 1016, Optical Materials Technology for Energy Efficiency and Solar Energy Conversion VII, (6 March 1989); doi: 10.1117/12.949945
Show Author Affiliations
Alia H. Musa, University of Baghdad (Iraq)
F. Y. M. Al-Shaikley, University of Baghdad (Iraq)

Published in SPIE Proceedings Vol. 1016:
Optical Materials Technology for Energy Efficiency and Solar Energy Conversion VII
Claes-Goeran Granqvist; Carl M. Lampert, Editor(s)

© SPIE. Terms of Use
Back to Top