Share Email Print

Proceedings Paper

Comparison of a Joule effect calibration system using Kanthal wire and a laser diode as heat sources
Author(s): Blas A. Maldonado; Maximiliano Bárcena-Soto; Norberto Casillas; Jorge L. Flores
Format Member Price Non-Member Price
PDF $17.00 $21.00

Paper Abstract

Here it is presented a comparison of two calibration techniques applied to a thermistor element used in a surface microcalorimeter which operates under Isoperibol conditions. Usually surface microcalorimeters employ a thermistor as a temperature sensing element, whose heat capacity requires to be evaluated before they can be used. One alternative method to estimate its heat capacity is by supplying a known amount of energy and detecting its temperature changes. Thus, surface heating can be achieved by different techniques; one of them is by supplying energy to the thermistor by passing current through a Ni-Cr coil wined around the glass bulb thermistor. A rather different and more convenient technique consists of directly illuminating a small well-defined thermistor area with an infrared 1550 nm wavelength laser beam, while detecting the thermistor temperature changes. Both procedures are thoroughly compared and the heat capacities obtained by both methods are presented.

Paper Details

Date Published: 3 December 2009
PDF: 6 pages
Proc. SPIE 7499, Seventh Symposium Optics in Industry, 749915 (3 December 2009); doi: 10.1117/12.849192
Show Author Affiliations
Blas A. Maldonado, Univ. de Guadalajara (Mexico)
Maximiliano Bárcena-Soto, Univ. de Guadalajara (Mexico)
Norberto Casillas, Univ. de Guadalajara (Mexico)
Jorge L. Flores, Univ. de Guadalajara (Mexico)

Published in SPIE Proceedings Vol. 7499:
Seventh Symposium Optics in Industry
Guillermo García Torales; Jorge L. Flores Núñez; Gilberto Gómez Rosas; Eric Rosas, Editor(s)

© SPIE. Terms of Use
Back to Top
Sign in to read the full article
Create a free SPIE account to get access to
premium articles and original research
Forgot your username?