Share Email Print
cover

Proceedings Paper

The measurement method of micro-involute spur gear based on micro-vision
Author(s): Fang Du; Zhi-jing Zhang; Lin Zhang; Xin Jin
Format Member Price Non-Member Price
PDF $17.00 $21.00

Paper Abstract

Aim at measuring basic parameters, geometric parameters and errors of tooth of micro-gears, a non-contact measurement method of micro-gear based on micro-vision is presented. In measurement, edge scanning and edge recognition based on process match principle were used to obtain accurate edge; the basic and geometric parameters could be measured by fitting the related edge data according with the definition of each parameter; the tooth profile errors were measured by building the measurement model in the direction of involute normal; and the tooth pitch errors were calculated by comparing between the nominal tooth pitch and each actual tooth pitch. The experimental results indicate that the essential micro-gear parameters are measured with high accuracy. And it also shows that this measurement method based on micro-vision can be applied to micro-spur gears successfully.

Paper Details

Date Published: 31 December 2008
PDF: 6 pages
Proc. SPIE 7130, Fourth International Symposium on Precision Mechanical Measurements, 71304E (31 December 2008); doi: 10.1117/12.819718
Show Author Affiliations
Fang Du, Beijing Institute of Technology (China)
Zhi-jing Zhang, Beijing Institute of Technology (China)
Lin Zhang, Beijing Institute of Technology (China)
Xin Jin, Beijing Institute of Technology (China)


Published in SPIE Proceedings Vol. 7130:
Fourth International Symposium on Precision Mechanical Measurements
Yetai Fei; Kuang-Chao Fan; Rongsheng Lu, Editor(s)

© SPIE. Terms of Use
Back to Top