Share Email Print
cover

Proceedings Paper

Thermal analysis and quality prediction of via hole drilled on Si device by short-pulse laser
Author(s): Kiyokazu Yasuda; Masahiro Yasuda; Kozo Fujimoto
Format Member Price Non-Member Price
PDF $17.00 $21.00

Paper Abstract

Laser drilling is one of the promising methods for manufacturing fine-patterned and noble devices in electronic packaging. In order to realize 3D packaging by via hole drilling on Si chip devices by short pulse laser without damage, we developed the basic method predicting heat damage based on thermal conduction by finite element analysis. Quantitative prediction of heat affected zone (HAZ) where temperature exceeds the threshold value was employed in variety of process parameters such as power density, pulse width and beam profiles of laser. Numerical result showed that melting zone (MZ) size by a single shot of excimer laser was nearly same as irradiated area size in case of 7 μm of irradiated diameter, 10.2 J/cm2 of fluencies and 50 ns to 1 μs of pulse width, and that HAZ size was independent of pulse width consequently. It was found that spatial beam profile did not affect MZ size although HAZ size was slightly changed. Thermal degradation was predicted to be enhanced in case that the beam was irradiated near the edge of chip.

Paper Details

Date Published: 19 February 2003
PDF: 6 pages
Proc. SPIE 4830, Third International Symposium on Laser Precision Microfabrication, (19 February 2003); doi: 10.1117/12.486535
Show Author Affiliations
Kiyokazu Yasuda, Osaka Univ. (Japan)
Masahiro Yasuda, Osaka Univ. (Japan)
Kozo Fujimoto, Osaka Univ. (Japan)


Published in SPIE Proceedings Vol. 4830:
Third International Symposium on Laser Precision Microfabrication
Isamu Miyamoto; Kojiro F. Kobayashi; Koji Sugioka; Reinhart Poprawe; Henry Helvajian, Editor(s)

© SPIE. Terms of Use
Back to Top