Share Email Print

Proceedings Paper

Laser spectrum line shape metrology at 193 nm
Author(s): Alexander I. Ershov; Gunasiri G. Padmabandu; Jeremy D. Tyler; Palash P. Das
Format Member Price Non-Member Price
PDF $17.00 $21.00

Paper Abstract

The spectral shape requirements for an ArF laser for 193 nm microlithography are expected to be about 2X tighter than at 248nm. This is in part due to the dispersion of fused silica and CaD2 at 193nm and in part due to the push by the lens designers towards higher NA lenses. However, unlike 248nm, it is likely that the process engineer may not be satisfied with simple spectral bandwidth measurements of Full-Width-At-Half-Maximum. Instead, the knowledge of the compete spectral shape may be required, since it is the total shape that has an impact on the lens performance. This requirement may have significant impact on corresponding metrology tools. These tools should be either portable or built into the laser. They should be able to provide continuous feedback to the process engineer as far as the lens performance is considered. Present paper discuses recent developments in 193nm metrology which can be implemented as a part of laser on-board diagnostics or as a field service tool, and is capable of accurately measuring the laser spectrum shape. This information, together with propriety lens parameters, will allow process engineer to accurately evaluate the aberrations due to the laser line shape.

Paper Details

Date Published: 5 July 2000
PDF: 13 pages
Proc. SPIE 4000, Optical Microlithography XIII, (5 July 2000); doi: 10.1117/12.388978
Show Author Affiliations
Alexander I. Ershov, Cymer, Inc. (United States)
Gunasiri G. Padmabandu, Cymer, Inc. (United States)
Jeremy D. Tyler, Cymer, Inc. (United States)
Palash P. Das, Cymer, Inc. (United States)

Published in SPIE Proceedings Vol. 4000:
Optical Microlithography XIII
Christopher J. Progler, Editor(s)

© SPIE. Terms of Use
Back to Top