Share Email Print

Proceedings Paper

Electronics improvements for optical resonators fabrication
Format Member Price Non-Member Price
PDF $17.00 $21.00

Paper Abstract

To obtain high quality factor optical resonator, we must reduces stresses at the periphery of their surface as mechanical treatments enable state-of-the art characteristics for the surface roughness. This process is driven by electronics significantly improved thanks to electronic boards based on the use of intensity pulses, coupled with feedback on several parameters for fitting the specific profile of the heating cycle. Sensor is based on K-type technology to reach specification up to 1000°C. Technology is based on the use of microcontroller, low noise operational amplifiers, field effect transistors and diode bridges and driven by a intensity signal.

Paper Details

Date Published: 5 November 2018
PDF: 6 pages
Proc. SPIE 10814, Optoelectronic Devices and Integration VII, 1081418 (5 November 2018); doi: 10.1117/12.2500665
Show Author Affiliations
Patrice Salzenstein, CNRS, UBFC, FEMTO-ST (France)
Mikhail Zarubin, CNRS, UBFC, FEMTO-ST (France)
Special Technological Ctr. (STC) (Russian Federation)

Published in SPIE Proceedings Vol. 10814:
Optoelectronic Devices and Integration VII
Xuping Zhang; Baojun Li; Changyuan Yu; Xinliang Zhang, Editor(s)

© SPIE. Terms of Use
Back to Top
Sign in to read the full article
Create a free SPIE account to get access to
premium articles and original research
Forgot your username?