Share Email Print
cover

Proceedings Paper

Application of FBG in the experimental measurements of structural elements deformation from cement composites
Author(s): Pavel Mec; Martin Stolarik; Stanislav Zabka; Martin Novak
Format Member Price Non-Member Price
PDF $17.00 $21.00

Paper Abstract

Monitoring deformations of structures or testing of supporting elements are important activities in life cycle of structures. Determined large deformation may indicate defect or failure of supporting structures. The aim of the experiments is to show another, less frequently used strain measurement method. The fibber Bragg grating sensor was used for measuring of the strain changes in simple supported concrete beam. These sensors based on optical fibers allow to measure the strain of the fiber by changing the wavelength of light in the deformed fiber. The article describes an experiment conducted at the Faculty of Civil engineering VŠB Technical University of Ostrava. The values measured by these sensors are compared with measurements using traditional methods.

Paper Details

Date Published: 9 October 2018
PDF: 6 pages
Proc. SPIE 10796, Electro-Optical Remote Sensing XII, 107960S (9 October 2018); doi: 10.1117/12.2325553
Show Author Affiliations
Pavel Mec, VŠB-Technical Univ. of Ostrava (Czech Republic)
Martin Stolarik, VŠB-Technical Univ. of Ostrava (Czech Republic)
Stanislav Zabka, VŠB-Technical Univ. of Ostrava (Czech Republic)
Martin Novak, VŠB-Technical Univ. of Ostrava (Czech Republic)


Published in SPIE Proceedings Vol. 10796:
Electro-Optical Remote Sensing XII
Gary Kamerman; Ove Steinvall, Editor(s)

© SPIE. Terms of Use
Back to Top