Share Email Print
cover

Proceedings Paper

EUV Infrastructure: EUV photomask backside cleaning (Conference Presentation)
Author(s): Bruce Fender; Dusty Leonhard; Hugo Breuer; Jack Stoof; My-Phung Van; Rudy J. M. Pellens; Reinout Dekkers; Jan-Pieter Kuijten

Paper Abstract

EUV Infrastructure: EUV photomask backside cleaning Applied Materials as first author: Bruce J. Fender, Dusty Leonhard, Hugo Breuer, Jack Stoof ASML: My Phung Van, Rudy Pellens, Reinout Dekkers, Jan Pieter Kuijten Due to electrostatic chucking of the backside of EUV masks, backside cleanliness in EUV lithography is an important factor. Contamination on the backside can cause damage to reticle (e-chuck), cross-contaminate to the scanner or cause local distortions in the reticle. Cleaning of the masks offers a solution to reduce the defectivity level on reticles. However, repeated cleaning on masks is known to have an impact on absorber, CD and reflectivity. Ideally, cleaning should occur without any alterations to the critical features on the front side of the mask. With the introduction of pellicles for EUV, there could be an additional drive for backside-only cleaning. In this work the GuardianTM Technology is introduced that enables backside cleaning without any cleaning impact on the reticle front side through a protective seal at the outer edge of the mask. The seal protects the front side during the backside clean. The cleaning process encompasses a single-sided pre-clean oxygen plasma treatment of the mask surface, followed by sonic cleaning, and ending with a rinse and dry step. Separating the mask backside from front side enables: • Backside cleaning without any cleaning impact on features on the mask front side. • The isolation allows an aggressive cleaning of the backside to ensure defect removal. • Processing of reticle with studs on the front side. This prevents unnecessary actions of stud removal and removal of the remaining glue after stud removal and subsequent gluing of the studs after cleaning. Just before chucking of a reticle, the defectivity level on the mask is initially inspected with an in-scanner reticle backside inspection tool. The GuardianTM cleaning process is able to remove the vast majority of the cleanable defects that could impact scanner performance. Post GuardianTM clean interferometric microscope defect review reveals the remaining defects > 25-μm-PSL are ~78% are indent/damage and 11% are defects with insignificant height to impact scanner performance or cleanliness.  

Paper Details

Date Published: 16 October 2017
PDF
Proc. SPIE 10450, International Conference on Extreme Ultraviolet Lithography 2017, 1045009 (16 October 2017);
Show Author Affiliations
Bruce Fender, Applied Materials, Inc. (United States)
Dusty Leonhard, Applied Materials, Inc. (United States)
Hugo Breuer, Applied Materials, Inc. (Netherlands)
Jack Stoof, Applied Materials BV (Netherlands)
My-Phung Van, ASML Netherlands B.V. (Netherlands)
Rudy J. M. Pellens, ASML Netherlands B.V. (Netherlands)
Reinout Dekkers, ASML Netherlands B.V. (Netherlands)
Jan-Pieter Kuijten, ASML Netherlands B.V. (Netherlands)


Published in SPIE Proceedings Vol. 10450:
International Conference on Extreme Ultraviolet Lithography 2017
Paolo A. Gargini; Patrick P. Naulleau; Kurt G. Ronse; Toshiro Itani, Editor(s)

© SPIE. Terms of Use
Back to Top
PREMIUM CONTENT
Sign in to read the full article
Create a free SPIE account to get access to
premium articles and original research
Forgot your username?
close_icon_gray