Share Email Print

Proceedings Paper

Laser additive manufacturing of multimaterial tool inserts: a simulation-based optimization study
Author(s): Sankhya Mohanty; Jesper Henri Hattel
Format Member Price Non-Member Price
PDF $17.00 $21.00

Paper Abstract

Selective laser melting is fast evolving into an industrially applicable manufacturing process. While components produced from high-value materials, such as Ti6Al4V and Inconel 718 alloys, are already being produced, the processing of multi-material components still remains to be achieved by using laser additive manufacturing. The physical handling of multi-material in a SLM setup continues to be a primary challenge along with the selection of process parameters/plan to achieve the desired results – both challenges requiring considerable experimental undertakings. Consequently, numerical process modelling has been adopted towards tackling the latter challenge in an effective manner. In this paper, a numerical simulation based optimization study is undertaken to enable selective laser melting of multi-material tool inserts. A standard copper specimen covered by a thin layer of nickel is chosen, over which a layer of steel has been deposited using cold-spraying technique, such as to protect the microstructure of Ni during selective laser melting. The process modelled thus entails additively manufacturing a steel tool insert around the multi-material specimen with a goal of achieving a dense product while preventing recrystallization in the Nickel layer. The process is simulated using a high-fidelity thermo-microstructural model with constant processing parameters to capture the effect on Nickel layer. Based on results, key structural and process parameters are identified, and subsequently an optimization study is conducted using evolutionary algorithms to determine the appropriate process parameter values as well as processing sequence. The optimized process plan is then used to manufacture real multi-material tool insert samples by selective laser melting.

Paper Details

Date Published: 24 February 2017
PDF: 10 pages
Proc. SPIE 10095, Laser 3D Manufacturing IV, 100950G (24 February 2017); doi: 10.1117/12.2253600
Show Author Affiliations
Sankhya Mohanty, Technical Univ. of Denmark (Denmark)
Jesper Henri Hattel, Technical Univ. of Denmark (Denmark)

Published in SPIE Proceedings Vol. 10095:
Laser 3D Manufacturing IV
Bo Gu; Henry Helvajian; Alberto Piqué; Corey M. Dunsky; Jian Liu, Editor(s)

© SPIE. Terms of Use
Back to Top
Sign in to read the full article
Create a free SPIE account to get access to
premium articles and original research
Forgot your username?