Optical magnetic response of upright plasmonic molecules in 3D metamaterial
Metamaterials are defined as an array of artificial subwavelength structures that frequently show unique optical behavior not found in nature.1, 2 Composites of these materials made with split-ring resonators (SRRs) have attracted wide attention owing to a number of extraordinary properties, including optical chirality,3 negative index of refraction,4 and optical spectrum manipulability.5 Metamaterials have application as nanorulers,6 luminescence enhancement,7 and ultrafast optical switches.8 The ability of SRRs to induce negative refraction was first studied in the microwave region in 2000.9 Since 2005, interest in them has extended to the optical frequency region to make the technology more broadly applicable.10
Despite their obvious appeal, fabrication of these structures in 3D presents significant challenges because of their limited spatial resolution. Consequently, to date most U-shaped SRRs (a configuration conducive to magnetic plasmon resonance) have been made in planar or multilayered form, some of which are 3D but on the scale of microns. One way to excite the magnetic plasmon resonance of planar SRRs requires applying off-normal incident light possessing the required magnetic vector field component.
![](images/Graphics/Newsroom/Imported-2011/003839/003839_10_fig1.jpg)
![](images/Graphics/Newsroom/Imported-2011/003839/003839_10_ieqn1.jpg)
To overcome these issues, we successfully constructed a photonic metamaterial by e-beam lithography using a precise alignment technique (under 10nm misalignment). The metamaterial consisted of an array of vertical (3D) U-shaped gold SRRs on the nanometer scale (nanorings). We then studied their optical properties both experimentally and using numerical simulations (see Figure 1).11,12 A special feature of our structures is that their magnetic plasmon resonance can be excited simultaneously by the electric and magnetic fields of normally incident light, providing a rich response. Electromagnetic resonance modes in 3D SRR structures have been little studied to date. Consequently, we focused our investigations on both the magnetic and bi-anisotropic magneto-electric susceptibilities of our built structures.
Figure 2 shows measured and simulated transmission spectra through the sample described in Figure 1. As expected, when illuminated by y-polarized light, the magnetic plasmon resonance of the 3D nanorings cannot be excited, and experiments as well as simulations show the transmission spectra to be nearly flat. In contrast, the nanorings exhibit significant optical response to x-polarized incident light, resulting in a pronounced dip in the transmission spectrum at a wavelength of 850nm. This resonant mode results from a ringlike current flowing on the surface of the 3D nanoring shown by finite-element simulation. The mode represents magnetic plasmon resonance with a magnetic dipole response that is excited by external light.
![](images/Graphics/Newsroom/Imported-2011/003839/003839_10_fig2.jpg)
![](images/Graphics/Newsroom/Imported-2011/003839/003839_10_ieqn2.jpg)
We then varied the structural details of the nanorings and carried out simulations to study their transmission spectra. Figure 3(a) shows the simulated spectra for nanorings with L1 (length of the bottom bar) changed from 110 to 150nm. The resonance mode (denoted as mode I) shifts to longer wavelengths as L1 increases, as predicted by the standing wave model. Figure 3(b) shows the evolution of transmission spectra as H2 (height of the prong) increases. Again, we found a redshift of the resonance mode similar to that in Figure 3(a). We found another resonance at a higher frequency (denoted as mode II) excited by x-polarized normal-incident light.
Resonance modes I and II show distinct responses to the magnetic field of incident light: see Figure 3(c) and (d). Mode I exhibits an enhanced magnetic field in the hollow of the off-plane U-shaped ring. In contrast, in mode II the magnetic field line is pushed outside the two standing prongs and enhanced around their center. The magnetic fields of modes I and II show parallel and anti-parallel responses to the magnetic field of incident light, respectively. The current distribution at the surface of the rings—see Figure 3(c) and (d), insets—perfectly explains the magnetic field patterns illustrated here. For example, in the case of mode II, a pair of anti-phase currents along the two prongs of the U-shaped ring—see Figure 3(d), inset—and the flowing current along the bottom result in a destructive magnetic response at the ring's center.
![](images/Graphics/Newsroom/Imported-2011/003839/003839_10_fig3.jpg)
In summary, we fabricated an array of 3D U-shaped SRRs. Compared with other methods of making such structures, our approach provides both smaller size and improved resolution. However, the height of our devices is limited by the thickness of the resist. We showed that the magnetic response of 3D SRRs can be excited simultaneously by electric and magnetic fields under normal incident illumination. In future work, we will investigate the coupling between two or more upright SRRs to generate complex and functionally dense 3D metamolecules with toroidal or so-called Fano resonance.
National Taiwan University
Taipei, Taiwan