SPIE Membership Get updates from SPIE Newsroom
  • Newsroom Home
  • Astronomy
  • Biomedical Optics & Medical Imaging
  • Defense & Security
  • Electronic Imaging & Signal Processing
  • Illumination & Displays
  • Lasers & Sources
  • Micro/Nano Lithography
  • Nanotechnology
  • Optical Design & Engineering
  • Optoelectronics & Communications
  • Remote Sensing
  • Sensing & Measurement
  • Solar & Alternative Energy
  • Sign up for Newsroom E-Alerts
  • Information for:
    Advertisers
SPIE Photonics West 2018 | Call for Papers

SPIE Journals OPEN ACCESS

SPIE PRESS

SPIE PRESS




Print PageEmail PageView PDF

Defense & Security

Improving navigation for groups of autonomous guided vehicles

Information generated from vehicle encounters aids localization during navigation signal outages.
19 September 2014, SPIE Newsroom. DOI: 10.1117/2.1201409.005593

Global navigation satellite systems (GNSS), including the well-known Global Positioning System, are widely used for localization purposes. In these systems, radio signals are transmitted from orbiting satellites. The received signals are used to derive the range (i.e., distance) to the individual satellites. The precise location of the user can then be determined through triangulation methods. The received signals, however, are very weak and can be further suppressed by obstructions such as buildings and trees. Conducting range measurements and localization of the user is therefore often impossible.

Purchase SPIE Field Guide to IR Systems, Detectors and FPAsNavigation using GNSS is commonly aided by combining the measurements with other data. For example, data from GNSS can be combined with data from inertial navigation systems (INS),1 cameras, or wireless communication systems (WiFi).2, 3 Most navigation systems are designed to be used by a single person or autonomous guided vehicle (AGV). A more interesting situation is also conceivable, in which a group of AGVs—which may have occasional encounters with each other—are performing a collaborative task.

We have considered this type of situation in recent work.4 Each AGV is equipped with its own combined INS/GNSS navigation system. According to general practice,1 we use a Kalman filter to blend the information from the INS and GNSS and to keep track of the position, velocity, and attitude (the so-called navigation state) of each AGV. These systems also keep track of the uncertainty of the navigation state. If, during an encounter between two AGVs, they detect that they are very close, it may be determined that they have the same approximate position. The distance between the two AGVs depends on the expected detection range (see Figure 1). After the encounter, the AGV that has a lower uncertainty on its position can act as a 'beacon' to the more uncertain AGV. These detections therefore generate new shared information that was not available before the encounter. We have developed a new method in which this information can be used to improve the estimated navigation states.


Figure 1. Cartoon illustrating the situation when two objects (e.g., cars) are in close proximity. An encounter is detected if their relative range is less than the expected detection range, Ld. After this encounter is detected, new navigation-related information is available.

We have formulated a mathematical relationship to combine the INS/GNSS information for each AGV with the encounter information. This equation relates the new type of information with the navigation states of the AGVs, i.e., , where is the difference between an actual measurement and a predicted—based on the estimated navigation state—measurement, is the difference between the estimated and true navigation state, and H is the ‘measurement matrix.’ For an intuitive first approach, we used the position of the more certain AGV as the actual measurement and the position of the less certain AGV as the predicted measurement. We also determined a measurement noise matrix. As a first approach, this can be derived as a weighted matrix that is based on the covariance of the more certain AGV's position state and the uncertainty of the encounter detection.

We built a simulation model of two (one for each simulated AGV, A and B) loosely coupled INS/GNSS navigation systems to test our method of distributed and possibly cooperative navigation. As shown in Figure 2, each AGV followed its own simulated trajectory. After a certain amount of time we simulated a GNSS outage, which caused the GNSS position information to be lost. Due to small inertial sensor errors and noise, there was then some INS drift. Once the GNSS outage ended, the navigation system quickly regained its accuracy. An encounter between the AGVs during the GNSS outage (about 45s after the start of the simulation) was detected. The results of the corrected position (and the uncertainty on the position of each AGV), based on the newly acquired information from this encounter, are shown in Figure 3. After the encounter, AGV B had a high certainty on its position and acted as a reference for AGV A. The position error of AGV A was therefore quickly reduced (the position error of AGV B was already low and did not improve significantly).


Figure 2. Plot of baseline (‘true’) trajectories for vehicle A and B, in x and y directions. Dotted lines represent estimated trajectories where simulated global navigation satellite system (GNSS) aiding was lost and there was resultant inertial navigation system (INS) drift. Once GNSS recommences, the drifted positions are quickly corrected.

Figure 3. Position errors in x and y directions (Δx,y) and uncertainties (σx,y) for vehicle A and B in the simulated INS/GNSS system, aided by encounter information. After about 20s there is a GNSS outage, which causes position errors to increase. Encounter information after about 45s, however, is used to reduce the position drift. Thin lines indicate the data corresponding to when encounter information was not used.

Our preliminary results indicate that encounter information can be used to aid a standard INS/GNSS navigation system when there are GNSS outages. We predict that more encounters, involving more than two AGVs, will produce even better results. It is also possible that unattended AGVs could be programmed to deliberately encounter one another when the position uncertainties are great. This would represent a new and effective means of cooperative navigation.

We have formulated and tested a new combined INS/GNSS navigation technique. Information acquired during encounters between two AGVs help reduce positional drift during GNSS outages. We are now planning to perform further simulations of our model with an increased number of vehicles. We hope to understand the level of navigation improvement as a function of vehicle number and number of encounters. In the future we will also be conducting practical tests of a real INS/GNSS system in densely built environments.


Marcel Ruizenaar
Technical Sciences
Netherlands Organization for Applied Scientific Research (TNO)
The Hague, The Netherlands

Marcel Ruizenaar graduated in 1985 with a BSc. He has worked at TNO for 27 years. He is now setting up a research team that will focus on the field of robust navigation. He is also the inventor of several patented localization and new sensor concepts.


References:
1. P. D. Groves, Principles of GNSS, Inertial, and Multisensor Integrated Navigation Systems, p. 540, Artech Print on Demand, 2008.
2. W. Chai, C. Chen, E. Edwan, J. Zhang, O. Loffeld, INS/Wi-Fi based indoor navigation using adaptive Kalman filtering and vehicle constraints, Workshop Positioning Navigation Commun. 9, p. 36-41, 2012.
3. J. F. Raquet, J. A. Shockley, K. A. Fisher, Determining absolute position using 3-axis magnetometers and the need for self-building world models, NATO Panel STO-EN-SET-197, 2013.
4. M. G. Ruizenaar, Encounter detection to improve navigation in a group of unattended vehicles, Proc. SPIE 9248, p. 9248-33, 2014. doi:10.1117/12.2074284