Share Email Print
cover

Proceedings Paper

Impact of EUVL mask surface roughness on an actinic blank inspection image and a wafer image
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

An impact of EUVL mask surface roughness on actinic inspection was studied. The background level (BGL) of an actinic inspection image is caused by the light scattered from the mask blank surface roughness. The BGL is found to be proportional to the square of the mask surface roughness measured by AFM. By using this proportionality coefficient, a global distribution of the surface roughness can be obtained at the same time while inspection a mask. On the other hand, any local variation of BGL indicates variation of the mask surface roughness at each pixel. Assuming that the roughness at a center pixel is 0.15 nm rms (SEMI standard specification) and those at the surrounding pixels are 0.1 nm rms, the signal intensity at the center pixel is found to be approximately the same as that of a 1.2 nm-high and 40 nm-wide programmed defect. In that case, CD error on a wafer image due to the reflectivity loss by the roughness is found to be not critical. This means that the local roughness should be less than 0.15 nm rms, and that the inspection system can detect such a local variation of the roughness with 100 % probability.

Paper Details

Date Published: 8 November 2012
PDF: 7 pages
Proc. SPIE 8522, Photomask Technology 2012, 85220H (8 November 2012); doi: 10.1117/12.964965
Show Author Affiliations
Takeshi Yamane, EUVL Infrastructure Development Ctr., Inc. (Japan)
Tsuneo Terasawa, EUVL Infrastructure Development Ctr., Inc. (Japan)


Published in SPIE Proceedings Vol. 8522:
Photomask Technology 2012
Frank E. Abboud; Thomas B. Faure, Editor(s)

© SPIE. Terms of Use
Back to Top