Share Email Print

Proceedings Paper

Estimating Heat Loads On Multistage Thermoelectric Heat Pumps
Author(s): Raymond Marlow; Porter B. Click
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

To optimize the design of a thermoelectric heat pump for minimum input power, it is necessary to make a good estimate of the heat load. Multistage thermoelectric heat pumps are required to cool temperature sensitive components to 233°K (-40°C) or colder. In these cases the relationship of Coefficient of Performance, COP, vs Cold Side Temperature, TC indicates that any small error in the heat load calculation is reflected as a large error in input power. The relationship of heat load and input power relative to cold side temperature is discussed in this paper. Graphical presentations are used to estimate the heat loads for these examples and to show the effect on input power. Typical examples are as follows: 1. Cooling of a multielement infrared detector array to 193°K (-80°C), 2. Cooling of a single element silicon laser sensor to a temperature of 163°K (-110°C), 3. Cooling a self scanned array DIP to 233°K (-40°C) in Nitrogen and 4, Cooling a self scanned array chip to 233°K (-40°C) in Zenon. Each example has specific problems in evaluating heat load and input power requirements.

Paper Details

Date Published: 15 December 1977
PDF: 10 pages
Proc. SPIE 0116, Solid-State Imaging Devices, (15 December 1977); doi: 10.1117/12.955647
Show Author Affiliations
Raymond Marlow, Marlow Industries, Inc. (United States)
Porter B. Click, Marlow Industries, Inc. (United States)

Published in SPIE Proceedings Vol. 0116:
Solid-State Imaging Devices
Jim Campbell, Editor(s)

© SPIE. Terms of Use
Back to Top