Share Email Print
cover

Proceedings Paper

Surface Modulations On Metaloptics Caused By Vibrations In The Microturning Respectively Fly-Cutting Process
Author(s): M. Weck; K. Modemann
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

The requirements for surface quality of workpieces such as metal-optics are increasing, specially if they are used as optics in high energy laser systems. This fact leads to an ongoing optimization effort of the microturning respectively fly-cutting process with a single point diamond tool. A selection of insufficiently machined workpieces has demonstrated that vibrations at the cutting zone modulate the surface contour. Recent measurements have shown that the static and dynamic compliance of ultraprecision machines has a great influence on these effects. In the past several ultraprecision machines have been studied and the results are presented here statistically. Further examinations have pointed out that it is possible to correlate the measured vibration amplitudes at tool and headstock during the cutting process with the generated texture on the workpiece.

Paper Details

Date Published: 11 April 1989
PDF: 8 pages
Proc. SPIE 1015, Micromachining Optical Components and Precision Engineering, (11 April 1989); doi: 10.1117/12.949448
Show Author Affiliations
M. Weck, Fraunhofer-Institut fur Produktionstechnologie (Germany)
K. Modemann, Fraunhofer-Institut fur Produktionstechnologie (Germany)


Published in SPIE Proceedings Vol. 1015:
Micromachining Optical Components and Precision Engineering
Peter Langenbeck, Editor(s)

© SPIE. Terms of Use
Back to Top