Share Email Print
cover

Proceedings Paper

Submicron Optical Lithography Using An I-Line Wafer Stepper
Author(s): S. Lee; S. Grillo; V. Miller
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

Optical lithography using an i-line wavelength (365 nm) has superior resolution compared to longer g- or h-line wave-lengths. This is due to the inverse relationship between the wavelength of the light and the diffraction-limited resolution of an imaging lens. The higher absorptivity of typical positive photo-resists at the i-line wavelength also enhances resolution. The half micron resolution capability of the Zeiss i-line 10:1 projection lens has been reported in a previous papers. This paper describes the performance of the THE 800SLR® Wafer Stepper with an i-line imaging lens. The i-line optics for the wafer stepper have presented difficulties in the areas of illuminator optimization, i-line spec-tral filter development, and wafer-to-reticle alignment. The reduced linewidth (0.5 micron) requires tighter system tolerances in the performance of the wafer stepper for linewidth control. The error budget to achieve these tight tolerances in the optical, mechanical, and electrical areas explained later in this paper. High throughput combined with submicron system capability enables i-line optical lithography to be superior to other non-optical lithography methods in production applications.

Paper Details

Date Published: 23 July 1985
PDF: 7 pages
Proc. SPIE 0538, Optical Microlithography IV, (23 July 1985); doi: 10.1117/12.947742
Show Author Affiliations
S. Lee, TRE Semiconductor Equipment Corporation (United States)
S. Grillo, TRE Semiconductor Equipment Corporation (United States)
V. Miller, TRE Semiconductor Equipment Corporation (United States)


Published in SPIE Proceedings Vol. 0538:
Optical Microlithography IV
Harry L. Stover, Editor(s)

© SPIE. Terms of Use
Back to Top