Share Email Print
cover

Proceedings Paper

Development of a stress sensor based on the piezoelectric lead zirconate titanate for impact stress measurement
Author(s): Yiming Liu; Bin Xu
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

The measurement of stress of concrete structures under impact loading and other strong dynamic loadings is crucial for the monitoring of health and damage detection. Due to its main advantages including availability, extremely high rigidity, high natural frequency, wide measuring range, high stability, high reproducibility, high linearity and wide operating temperature range, piezoelectric (Lead Zirconate Titanate, PZT) ceramic materials has been a widely used smart material for both sensing and actuation for monitoring and control in engineering structures. In this paper, a kind of stress sensor based on piezoelectric ceramics for impact stress measuring of concrete structures is developed. Because the PZT is fragile, in order to employ it for the health monitoring of concrete structures, special handling and treatment should be taken to protect the PZT and to make it survive and work properly in concrete. The commercially available PZT patch with lead wires is first applied with an insulation coating to prevent water and moisture damage, and then is packaged by jacketing it by two small precasted cylinder concrete blocks with enough strength to form a smart aggregate (SA). The employed PZT patch has a dimension of 10mm x 10mm x 0.3mm. In order to calibrate the PZT based stress sensor for impact stress measuring, a dropping hammer was designed and calibration test on the sensitivity of the proposed transducer was carried out with an industry charge amplifier. The voltage output of the stress sensor and the impact force under different free falling heights and impact mass were recorded with a high sampling rate data acquisition system. Based on the test measurements, the sensibility of the PZT based stress sensor was determined. Results show that the output of the PZT based stress sensor is proportional to the stress level and the repeatability of the measurement is very good. The self-made piezoelectric stress sensor can be easily embedded in concrete and provide reliable stress sensing under dynamic loadings.

Paper Details

Date Published: 3 April 2012
PDF: 8 pages
Proc. SPIE 8409, Third International Conference on Smart Materials and Nanotechnology in Engineering, 84090Y (3 April 2012); doi: 10.1117/12.923427
Show Author Affiliations
Yiming Liu, Hunan Univ. (China)
Bin Xu, Hunan Univ. (China)


Published in SPIE Proceedings Vol. 8409:
Third International Conference on Smart Materials and Nanotechnology in Engineering
Jinsong Leng; Yoseph Bar-Cohen; In Lee; Jian Lu, Editor(s)

© SPIE. Terms of Use
Back to Top