Share Email Print
cover

Proceedings Paper

Active material for fiber core made by powder-in-tube method: subsequent homogenization by means of stack-and-draw technique
Author(s): Vladimir V. Velmiskin; Olga N. Egorova; Vladimir Mishkin; Konstantin Nishchev; Sergey L. Semjonov
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

A procedure for the preparation of optically homogeneous glass for fiber preforms through sintering of coarse oxide particles and further processing of the resultant glass, including several drawing and stacking steps, is described. Reducing the pressure to 10-2 Torr during sintering considerably reduced the amount of gas bubbles in Yb/Al-doped silica glass and decreased the background loss to 100 dB/km after the third drawing-stacking-consolidation cycle. For comparison, a fiber singly doped with alumina was fabricated by the same procedure as above. The level of wavelength- independent losses in that fiber was 65 dB/km.

Paper Details

Date Published: 25 April 2012
PDF: 8 pages
Proc. SPIE 8426, Microstructured and Specialty Optical Fibres, 84260I (25 April 2012); doi: 10.1117/12.922188
Show Author Affiliations
Vladimir V. Velmiskin, Fiber Optics Research Ctr. (Russian Federation)
Olga N. Egorova, Fiber Optics Research Ctr. (Russian Federation)
Vladimir Mishkin, Ogarev State Univ. (Russian Federation)
Konstantin Nishchev, Ogarev State Univ. (Russian Federation)
Sergey L. Semjonov, Fiber Optics Research Ctr. (Russian Federation)


Published in SPIE Proceedings Vol. 8426:
Microstructured and Specialty Optical Fibres
Kyriacos Kalli; Alexis Mendez, Editor(s)

© SPIE. Terms of Use
Back to Top