Share Email Print
cover

Proceedings Paper

PV-MCT working standard radiometer
Author(s): George P. Eppeldauer; V. B. Podobedov
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

Sensitive infrared working-standard detectors with large active area are needed to extend the signal dynamic range of the National Institute of Standards and Technology (NIST) pyroelectric transfer-standards used for infrared spectral power responsivity calibrations. Increased sensitivity is especially important for irradiance mode responsivity measurements. The noise equivalent power (NEP) of the NIST used pyroelectric transfer-standards is about 8 nW/Hz1/2, equal to a D*= 5.5 x 107 cm Hz1/2/W. A large-area photovoltaic HgCdTe (PV-MCT) detector was custom made for the 2.5 μm to 11 μm wavelength range using a 4-stage thermoelectric cooler. At least an order of magnitude lower NEP was expected than that of the pyroelectric transfer-standards to measure irradiance. The large detector area was produced with multiple p-n junctions. The periodical, multiple-junction structure produced a spatial non-uniformity in the detector response. The PV-MCT radiometer was characterized for spatial non-uniformity of response using different incident beam sizes to evaluate the uncertainty component caused by the spatial non-uniformity. The output voltage noise and also the current and voltage responsivities were evaluated at different signal gains and frequencies. The output voltage noise was decreased and the voltage responsivity was increased to lower the NEP of the radiometer. The uncertainty of the spectral power responsivity measurements was evaluated. It is recommended to use a bootstrap type trans-impedance amplifier along with a cold field-of-view limiter to improve the NEP of the PV-MCT radiometer.

Paper Details

Date Published: 18 May 2012
PDF: 10 pages
Proc. SPIE 8355, Infrared Imaging Systems: Design, Analysis, Modeling, and Testing XXIII, 835505 (18 May 2012); doi: 10.1117/12.918599
Show Author Affiliations
George P. Eppeldauer, National Institute of Standards and Technology (United States)
V. B. Podobedov, National Institute of Standards and Technology (United States)


Published in SPIE Proceedings Vol. 8355:
Infrared Imaging Systems: Design, Analysis, Modeling, and Testing XXIII
Gerald C. Holst; Keith A. Krapels, Editor(s)

© SPIE. Terms of Use
Back to Top