Share Email Print
cover

Proceedings Paper

Comparison of the measurements of an experimental endoscope tester with the Dovideq MDE endoscope test system for two hospitals
Author(s): Herke Jan Noordmans; Martin W. Nelisse; Menno de Braak; Bert Dommerholt; Henk van den Brink
Format Member Price Non-Member Price
PDF $14.40 $18.00
cover GOOD NEWS! Your organization subscribes to the SPIE Digital Library. You may be able to download this paper for free. Check Access

Paper Abstract

In minimal invasive surgery, rigid endoscopes are used to view inside the body through natural or artificial made orifices. As the price of a rigid endoscope is high, they are being constantly re-used after a cleaning and steam sterilization procedure at the Department of Central Sterilization. However, due to mechanical, chemical and thermal stresses, endoscopes degrade over time. To determine whether an endoscope still provides sufficient quality, personnel of the Department of Central Sterilization visually inspect the outside and inside of an endoscope. In practice this check is hard as it appears difficult to tell whether an image is good enough as it should be compared to the image of an new endoscope of the same type. Because of the large diversity in endoscopes, the variation of image quality of new endoscope is already so large, that it is difficult to perform this manual check objectively. In this paper we describe the results of using an experimental test bench to measure the optical quality of endoscopes over the years 2007-2011. The system is based on measuring the illumination pathway using a white LED and photo cell and the viewing pathway using a LCD generated test pattern and high resolution camera. The measurements show that endoscopes roughly degrade 20% per year, but also that the variation in degradation is so high and uncorrelated to the type of endoscope that structural measurement of the quality of endoscopes may be a prerequisite. Looking at the system itself, it appeared that although the system had sufficient stability over these years to allow conclusions, it has too much drawbacks to be used at the Department of Central Sterilization, like the stability of the LCD screen, loosing track of endoscopes when they are placed in another basket and the large number of manual steps needed to perform a measurement. For this reasons we present a new design of an endoscope measurement system, called the MDE, a Measurement Device for Endoscopes. It is based on comparing the endoscope image of the inside of a marker sphere with that of a new one. After a test run at the St Jansdal clinic in Harderwijk, the Netherlands, from March to December 2011, the system will be re-designed the coming months to include endoscope labeling with a data matrix, detection of broken illumination fibers and lenses and scanning of water and dust particles. Aimed to be commercially available from the end of 2012, we hope that this system will be a valuable device for assuring the optical quality of endoscopes in clinical practice.

Paper Details

Date Published: 28 February 2012
PDF: 9 pages
Proc. SPIE 8215, Design and Quality for Biomedical Technologies V, 821508 (28 February 2012); doi: 10.1117/12.909067
Show Author Affiliations
Herke Jan Noordmans, Univ. Medical Ctr. Utrecht (Netherlands)
Martin W. Nelisse, Univ. Medical Ctr. Utrecht (Netherlands)
Menno de Braak, DOVIDEQ medical BV (Netherlands)
Bert Dommerholt, DOVIDEQ medical BV (Netherlands)
Henk van den Brink, Univ. Medical Ctr. Utrecht (Netherlands)


Published in SPIE Proceedings Vol. 8215:
Design and Quality for Biomedical Technologies V
Ramesh Raghavachari; Rongguang Liang, Editor(s)

© SPIE. Terms of Use
Back to Top