Share Email Print
cover

Proceedings Paper

The non-source temperature calibration method of multi-spectral pyrometer
Author(s): Kun Sun; Xiaogang Sun; Jingmin Dai; Li Wang
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

At present, Multi-spectral pyrometer (MSP) used in high-temperature measurement has already had high resolution and high signal to noise ratio. However, the non-source temperature (higher than 3000°C) calibration falls far behind the development of MSP and has already seriously hindered the precision and application range of the pyrometer. In order to break through the limitation of calibration of non-source temperature, a new calibration method has been put forward in this paper. The temperature-voltage (T-U) model is formed based on power function where output voltage U of the MSP is derived from its corresponding known temperature point. Based on the model, Derivative least square method is used to obtain the parameters of the model to realize the non-source temperature calibration. Both theoretical and experimental data have proved the efficiency and precision of the calibration method. In addition, within the spectral range of high-temperature measurement pyrometer (0.4um~1.1um), the theoretical aberration within 1800°C extrapolation range is less than 13.54°C.

Paper Details

Date Published: 30 November 2011
PDF: 9 pages
Proc. SPIE 8201, 2011 International Conference on Optical Instruments and Technology: Optoelectronic Measurement Technology and Systems, 82011O (30 November 2011); doi: 10.1117/12.905826
Show Author Affiliations
Kun Sun, Harbin Institute of Technology (China)
Xiaogang Sun, Harbin Institute of Technology (China)
Jingmin Dai, Harbin Institute of Technology (China)
Li Wang, Harbin Institute of Technology (China)


Published in SPIE Proceedings Vol. 8201:
2011 International Conference on Optical Instruments and Technology: Optoelectronic Measurement Technology and Systems
Xinyong Dong; Xiaoyi Bao; Perry Ping Shum; Tiegen Liu, Editor(s)

© SPIE. Terms of Use
Back to Top