Share Email Print

Proceedings Paper

Signal processing for imaging and mapping ladar
Format Member Price Non-Member Price
PDF $14.40 $18.00
cover GOOD NEWS! Your organization subscribes to the SPIE Digital Library. You may be able to download this paper for free. Check Access

Paper Abstract

The new generation laser-based FLASH 3D imaging sensors enable data collection at video rate. This opens up for realtime data analysis but also set demands on the signal processing. In this paper the possibilities and challenges with this new data type are discussed. The commonly used focal plane array based detectors produce range estimates that vary with the target's surface reflectance and target range, and our experience is that the built-in signal processing may not compensate fully for that. We propose a simple adjustment that can be used even if some sensor parameters are not known. The cost for the instantaneous image collection is, compared to scanning laser radar systems, lower range accuracy. By gathering range information from several frames the geometrical information of the target can be obtained. We also present an approach of how range data can be used to remove foreground clutter in front of a target. Further, we illustrate how range data enables target classification in near real-time and that the results can be improved if several frames are co-registered. Examples using data from forest and maritime scenes are shown.

Paper Details

Date Published: 5 October 2011
PDF: 14 pages
Proc. SPIE 8186, Electro-Optical Remote Sensing, Photonic Technologies, and Applications V, 818607 (5 October 2011); doi: 10.1117/12.901799
Show Author Affiliations
Christina Grönwall, Swedish Defence Research Agency (Sweden)
Linköping Univ. (Sweden)
Gustav Tolt, Swedish Defence Research Agency (Sweden)

Published in SPIE Proceedings Vol. 8186:
Electro-Optical Remote Sensing, Photonic Technologies, and Applications V
Gary J. Bishop; Gary W. Kamerman; Ove Steinvall; John D. Gonglewski; Keith L. Lewis, Editor(s)

© SPIE. Terms of Use
Back to Top