Share Email Print
cover

Proceedings Paper

Stabilization processes and air mass influences for outdoor exposure of thin film modules
Author(s): Jochen Wirth; Katrin Scharmach; Karl-Anders Weiss; Michael Köhl
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

Various types of modules were installed on a outdoor test facility. IV-curves of all these modules are measured every ten minutes. Measured irradiation, module temperature and air mass are used for analysis and comparison of the IV-curves. The influence of the respective air mass was higher than expected. Different correction procedures have been compared. Best results are achieved when the data are selected in a small range of air mass and module temperature and corrected to the same irradiation. Modules of the same types like the outdoor exposed modules were stored without irradiation for some years. Afterwards, they were exposed at the outdoor test site together with the other modules. Comparison of the module data of the same type allows the investigation of the stabilisation behaviour of the modules directly.

Paper Details

Date Published: 13 September 2011
PDF: 8 pages
Proc. SPIE 8110, Thin Film Solar Technology III, 81100K (13 September 2011); doi: 10.1117/12.893698
Show Author Affiliations
Jochen Wirth, Fraunhofer-Institut für Solare Energiesysteme (Germany)
Katrin Scharmach, Fraunhofer-Institut für Solare Energiesysteme (Germany)
Karl-Anders Weiss, Fraunhofer-Institut für Solare Energiesysteme (Germany)
Michael Köhl, Fraunhofer-Institut für Solare Energiesysteme (Germany)


Published in SPIE Proceedings Vol. 8110:
Thin Film Solar Technology III
Louay A. Eldada, Editor(s)

© SPIE. Terms of Use
Back to Top