Share Email Print
cover

Proceedings Paper

LCD failure evaluation methods and application to effect of dc drive
Author(s): Lu Lu; Aman Alagh; Philip J. Bos
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

In this paper, we first investigated the degradation of the performance of liquid crystals display (LCD) units after driving by a DC bias. Missed segments were found in the test LCD units. By carefully investigating the alignment layer and ITO layer separately, an explanation of the ITO failure is proposed: voltages applied to the liquid crystal cell causes accumulation of charged impurities or ions, resulting in a decomposition reaction of ITO in regions where segment and common planes overlap and there are scratches on the PI layer. Consequent, missing segments in the corresponding regions is generated. To prevent this kind of degradation, we studied the correlation between the alignment layer and ions adsorption. Both organic alignment layer (PI2555, SE1211, and FPI) and inorganic alignment layer (SiOx, SiO2, and Al203) are analyzed by residual DC and voltage holding ratio measurement. A correlation between ion adsorption and the dielectric constant of the alignment layer is demonstrated. Alignment layer with a smaller dielectric constant is good for reducing ion adsorption in the alignment layer. Alignment layer with a bigger dielectric constant is good for reducing mobile ions in the LC device, and could be used in non-active areas of the liquid crystal device to remove ion from the active area.

Paper Details

Date Published: 7 September 2011
PDF: 6 pages
Proc. SPIE 8114, Liquid Crystals XV, 811416 (7 September 2011); doi: 10.1117/12.893608
Show Author Affiliations
Lu Lu, Kent State Univ. (United States)
Aman Alagh, Okaya Electric America, Inc. (United States)
Philip J. Bos, Kent State Univ. (United States)


Published in SPIE Proceedings Vol. 8114:
Liquid Crystals XV
Iam Choon Khoo, Editor(s)

© SPIE. Terms of Use
Back to Top