Share Email Print
cover

Proceedings Paper

Single domain wall magnetoresistance electron-beam fabrication and magnetoresistance measurement
Author(s): Yudong Wang; C. H. de Groot; D. Claudio-González; M. D. B. Charlton
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

We report a reproducible top down fabrication procedure for a single domain wall magnetoresistance H-shaped device. A bi-layer e-beam lift-off process is used and the e-beam exposure dose sensing technique and proximity effect correction are discussed, together with a method to reduce the alignment tolerance to below 20 nanometer. The domain wall width is constrained down to 37nm and room temperature domain wall magnetoresistance ratio of 0.3% was detected. The dependence of switching magnetic field to domain width will be discussed, as well as the maximum domain width which can retain its magnetisation aligned along the long axis at zero field which is found to be 210nm in our experiment.

Paper Details

Date Published: 15 September 2011
PDF: 7 pages
Proc. SPIE 8100, Spintronics IV, 81000P (15 September 2011); doi: 10.1117/12.892299
Show Author Affiliations
Yudong Wang, Univ. of Southampton (United Kingdom)
C. H. de Groot, Univ. of Southampton (United Kingdom)
D. Claudio-González, Univ. de Guanajuato (Mexico)
M. D. B. Charlton, Univ. of Southampton (United Kingdom)


Published in SPIE Proceedings Vol. 8100:
Spintronics IV
Henri-Jean M. Drouhin; Jean-Eric Wegrowe; Manijeh Razeghi, Editor(s)

© SPIE. Terms of Use
Back to Top