Share Email Print
cover

Proceedings Paper

Variable isotropy Deep RIE process for through wafer via holes manufacturing
Author(s): Dan Vasilache; Sabrina Colpo; Flavio Giacomozzi; Sabina Ronchin; Abdul Qader Ahsan Qureshi; Benno Margesin
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

This paper reports a method on the manufacturing of through wafer via holes in silicon with tapered walls by Deep Reactive Ion Etching (DRIE) using the opportunity to change the isotropy in the DRIE equipments during processing. By using consecutively anisotropic and isotropic etching steps it is possible to enlarge the dimension of via holes on one side of the wafer, while on the other side dimension is set by the initial etching window. The method was used for two etching windows sizes (100μm and 20μm respectively) on 200μm and 300μm thick wafers. The aim was to manufacture tapered walls via having a good control over the walls angle. Different Bosch process recipes providing different walls roughness were used. Via holes with tapered walls (2° to 22°) were manufactured using this method. An angle deviation smaller than 10% of the manufactured via holes along the wafers was observed.

Paper Details

Date Published: 5 May 2011
PDF: 9 pages
Proc. SPIE 8066, Smart Sensors, Actuators, and MEMS V, 80662J (5 May 2011); doi: 10.1117/12.887196
Show Author Affiliations
Dan Vasilache, FBK-irst (Italy)
National Research and Development Institute in Microtechnology (Romania)
Sabrina Colpo, FBK-irst (Italy)
Flavio Giacomozzi, FBK-irst (Italy)
Sabina Ronchin, FBK-irst (Italy)
Abdul Qader Ahsan Qureshi, FBK-irst (Italy)
Benno Margesin, FBK-irst (Italy)


Published in SPIE Proceedings Vol. 8066:
Smart Sensors, Actuators, and MEMS V
Ulrich Schmid; José Luis Sánchez-Rojas; Monika Leester-Schaedel, Editor(s)

© SPIE. Terms of Use
Back to Top