Share Email Print
cover

Proceedings Paper

Workpiece surface quality and the influence factors when high-speed milling of SiCp/2009Al composite
Author(s): Yingfei Ge; Jiuhua Xu; Yucan Fu
Format Member Price Non-Member Price
PDF $17.00 $21.00
cover GOOD NEWS! Your organization subscribes to the SPIE Digital Library. You may be able to download this paper for free. Check Access

Paper Abstract

Surface finish, surface generation and the influence factors were investigated when high speed milling SiCp/2009Al composites using polycrystalline diamond (PCD) tools. The results showed that the surface roughness Ra0.207-0.542μm and Rz2.02-5.20μm can be attained when tool flank wear VB is less than 0.09mm under the present cutting conditions. With the increasing wear of the cutting tools, the value of the machined surface roughness significantly increased. The machined surfaces included many defects of pits, voids, microcracks, grooves, protuberances, matrix tearing and smearing and so on. The depth of deformation layers were confined to 20-35μm. Among the factors which affected Ra, reinforcement volume fraction was the most significant factor and followed by cutting speed and feed rate. For the side face, the significance order of the factors which affected Rz can be ranged as reinforcement volume fraction, cutting speed, feed rate and radial depth of cut. Material swelling and side flow, tool-workpiece relative vibration, feed rate and tool nose radius, removal mode of SiC particles were the main mechanisms of surface generation.

Paper Details

Date Published: 24 May 2011
PDF: 6 pages
Proc. SPIE 7997, Fourth International Seminar on Modern Cutting and Measurement Engineering, 799706 (24 May 2011); doi: 10.1117/12.886600
Show Author Affiliations
Yingfei Ge, Nanjing Univ. of Aeronautics & Astronautics (China)
Nanjing Institute of Technology (China)
Jiuhua Xu, Nanjing Univ. of Aeronautics & Astronautics (China)
Yucan Fu, Nanjing Institute of Technology (China)


Published in SPIE Proceedings Vol. 7997:
Fourth International Seminar on Modern Cutting and Measurement Engineering
Jiezhi Xin; Lianqing Zhu; Zhongyu Wang, Editor(s)

© SPIE. Terms of Use
Back to Top