Share Email Print
cover

Proceedings Paper

Hot-wire probe used for measurement of one dimensional flow with bidirection
Author(s): Chengxu Tu
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

In order to solve the difficulties of the measurement of one-dimensional and bi-direction flow by a hot-wire probe, a test method and the model experiment are presented in this paper. Based on the exiting hot-wire sensor, another same sensor is added. The two sensors are installed in parallel whose distance is 6 times their diameters, and they are separately connected to the controller. If the flow goes around two circular cylinders in tandem with the low Reynolds number, an obvious velocity drop between free-stream and gap flow can be found. Consequently, the velocity detected by the upstream sensor is higher than that by the downstream one. Because the relatively fixed position of the pair of sensors has been determined beforehand, the direction of the one-dimensional flow can be deduced from the plus and minus of velocity drop detected by the two sensors.

Paper Details

Date Published: 31 December 2010
PDF: 7 pages
Proc. SPIE 7544, Sixth International Symposium on Precision Engineering Measurements and Instrumentation, 754431 (31 December 2010); doi: 10.1117/12.885409
Show Author Affiliations
Chengxu Tu, China Jiliang Univ. (China)


Published in SPIE Proceedings Vol. 7544:
Sixth International Symposium on Precision Engineering Measurements and Instrumentation
Jiubin Tan; Xianfang Wen, Editor(s)

© SPIE. Terms of Use
Back to Top