Share Email Print
cover

Proceedings Paper

Experimental method for determination of a suitable temperature range for glasses used in precision molding
Author(s): Tao Ma; Fan Chen; Jingchi Yu
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

Viscosity of glass is one of its important technological properties. It is usually adopted as a mark in controlling and evaluating the workability of glass. The viscous features in a glass forming process are strongly relevant to the temperature distribution. Appropriate procedure setting and controlling of temperature is an essential issue for precision glass molding. But the characteristic viscosity of glass is difficult to be observed directly in a practical lens molding. It's not convenient to set up the molding conditions caused by the differences between theoretical data and actual system. The purpose of this experimental study is intended to provide a simple and reliable method for determination of suitable temperature intervals of glasses used in the precision molding fabrication which meets the requirements of process tolerances in the industrial productions. The average glass deforming force and center thickness of molded lens are taken as the two conditions of determination principle for molding temperature ranges. The average force should not less than the minimum value of measurement accuracy and the lens thickness should reach the design target in these temperature ranges. These two conditions are easy to be measured and fit for application in the engineering. The molding temperature ranges of several kinds of glass were obtained in this project. One of them is Schott optical glass P-LASF51 which is selected for evaluating and validating this method. Its suitable molding temperature range is from 590 to 614 . The results of molding experiments demonstrate the method is effective and feasible.

Paper Details

Date Published: 7 October 2010
PDF: 5 pages
Proc. SPIE 7655, 5th International Symposium on Advanced Optical Manufacturing and Testing Technologies: Advanced Optical Manufacturing Technologies, 76553H (7 October 2010); doi: 10.1117/12.866665
Show Author Affiliations
Tao Ma, Suzhou Univ. (China)
Fan Chen, Suzhou Univ. (China)
Schott Glass Technologies Co., Ltd. (China)
Jingchi Yu, Suzhou Univ. (China)


Published in SPIE Proceedings Vol. 7655:
5th International Symposium on Advanced Optical Manufacturing and Testing Technologies: Advanced Optical Manufacturing Technologies
Li Yang; Yoshiharu Namba; David D. Walker; Shengyi Li, Editor(s)

© SPIE. Terms of Use
Back to Top