Share Email Print
cover

Proceedings Paper

MRI-compatible noninvasive continuous blood pressure measurement using fiber optics
Author(s): Juha Harja; Teemu S. Myllylä; Risto A. Myllylä
Format Member Price Non-Member Price
PDF $17.00 $21.00

Paper Abstract

This report focuses on designing and implementing a non-invasive blood pressure measuring device capable of being used during magnetic resonance imaging. This device is based on measuring pulse wave velocity in arterial blood and using the obtained result to estimate diastolic blood pressure. Pulse transit times are measured by two fibre optical accelerometers placed over chest and carotid artery. The fabricated accelerometer contains two static fibres and a cantilever beam. The free end of the beam is angled at 90 degrees to act as a reflecting surface. Optical fibres are used for both illuminating the surface and receiving the reflected light. Acceleration applied to the sensor causes deflection of the beam, whereupon the amount of reflected light changes. The sensor output voltage is proportional to the intensity of the reflected light. Tests conducted on the electronics and sensors inside an MRI room during scanning proved that the device is MR conditional. No artifacts or distortions were detected.

Paper Details

Date Published: 11 February 2010
PDF: 7 pages
Proc. SPIE 7547, Saratov Fall Meeting 2009: International School for Junior Scientists and Students on Optics, Laser Physics, and Biophotonics, 75470F (11 February 2010); doi: 10.1117/12.855056
Show Author Affiliations
Juha Harja, Univ. of Oulu (Finland)
Teemu S. Myllylä, Univ. of Oulu (Finland)
Risto A. Myllylä, Univ. of Oulu (Finland)


Published in SPIE Proceedings Vol. 7547:
Saratov Fall Meeting 2009: International School for Junior Scientists and Students on Optics, Laser Physics, and Biophotonics
Valery V. Tuchin; Elina A. Genina, Editor(s)

© SPIE. Terms of Use
Back to Top