Share Email Print
cover

Proceedings Paper

Dusty plasmas for on-site spectroscopic analysis of water sources
Author(s): John Sweeney; Chester G. Wilson
Format Member Price Non-Member Price
PDF $14.40 $18.00
cover GOOD NEWS! Your organization subscribes to the SPIE Digital Library. You may be able to download this paper for free. Check Access

Paper Abstract

This paper reports on a low-cost, borosilicate glass-based spectroscopic sensor for the detection of water contaminants. 10 μL water samples are inserted into a sandblasted sample reservoir in a borosilicate glass substrate and are partially evaporated with a 200 nm thin-film Cr microheater/cathode patterned to the bottom of the reservoir. The relative contaminant concentration within the partially evaporated sample is greater, providing a means of measuring lower concentrations of impurities. An on-chip plasma discharge is stuck to the sample, sputtering the water contaminants into the discharge, doping its spectral emissions. Cu and Fe impurities are detected at 10 ppm in a 2.5% HNO3 solution and Ca and Mg contaminants are detected at 100 ppm. The on-chip microheater yields temperature changes as high as 96 °C when supplied with 100 mA. Multiple single-use sensors can be fabricated inexpensively on the borosilicate glass substrate using simple, standard photolithography techniques.

Paper Details

Date Published: 17 September 2009
PDF: 8 pages
Proc. SPIE 7484, Optically Based Biological and Chemical Detection for Defence V, 748404 (17 September 2009); doi: 10.1117/12.830110
Show Author Affiliations
John Sweeney, Louisiana Tech Univ. (United States)
Chester G. Wilson, Louisiana Tech Univ. (United States)


Published in SPIE Proceedings Vol. 7484:
Optically Based Biological and Chemical Detection for Defence V
John C. Carrano; Charles J. Collins, Editor(s)

© SPIE. Terms of Use
Back to Top