Share Email Print
cover

Proceedings Paper

Research on optical measurement technology of optical multifilament basic parameters
Author(s): Guohui Zhou; Jianhua Wang
Format Member Price Non-Member Price
PDF $14.40 $18.00
cover GOOD NEWS! Your organization subscribes to the SPIE Digital Library. You may be able to download this paper for free. Check Access

Paper Abstract

The transverse section of optical multifilament is a six-sided cylinder, and the diameters of its circumcircle and excircle are the basic parameters. It is necessary that these parameters hold consistency. In this paper, the 2-D laser scanning technology is provided to measure these basic parameters of optical multifilament. To generate scanning beam with even palstance, DC moment motor is used to drive the eight-sided prism. The generated scanning beam is changed to constant velocity and parallel scanning beam by fθ lens. The parallel scanning beam passing through the measured optical multifilament is gathered onto the photoelectric conversion to make two edges of multifilament signal. By calculating the interval between two edge signals, the projection sizes on two orthogonality directions can be achieved, and then the diameters of circumcircle and excircle can be calculated. This paper provides the measuring mathematic model, analyzes the measuring error sources in detail and schedules the compensating tactics.

Paper Details

Date Published: 20 May 2009
PDF: 6 pages
Proc. SPIE 7283, 4th International Symposium on Advanced Optical Manufacturing and Testing Technologies: Optical Test and Measurement Technology and Equipment, 72833W (20 May 2009); doi: 10.1117/12.828794
Show Author Affiliations
Guohui Zhou, Harbin Normal Univ. (China)
Jianhua Wang, Harbin Normal Univ. (China)


Published in SPIE Proceedings Vol. 7283:
4th International Symposium on Advanced Optical Manufacturing and Testing Technologies: Optical Test and Measurement Technology and Equipment
Yudong Zhang; James C. Wyant; Robert A. Smythe; Hexin Wang, Editor(s)

© SPIE. Terms of Use
Back to Top