Share Email Print
cover

Proceedings Paper

New approach to workpiece localization in subaperture stitching interferometric testing
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

Large aperture optics have been used more and more widely in modern optical system. But the testing of its surface quality is very difficult. The circular sub-aperture stitching (CSAS) testing method can effectively extend the interferometer's vertical dynamic range and enhance its lateral resolution, so it may be the best solution to the testing of large aperture optics. Actually, the CSAS method can be viewed as a special workpiece localization problem. If the pose data of all sub-apertures obtained are accurate enough, the sub-aperture data can be directly stitched together to create a map of the full aperture. In this paper, a CSAS system will be introduced. Its motion mechanism has seven degrees of freedom. This brings some trouble for obtaining the optics' accurate pose data along with the motion error's accumulation. So a stereovision system is added. By exploiting appropriate scheme and algorithm, it can directly give out the optics' accurate pose data. This provides an effective initial value for the stitching algorithm. Finally, a 150mm flat and a 100mm convex sphere is tested using this method, and the experimental results is given to show the effect of this method and the efficiency of the CSAS system.

Paper Details

Date Published: 17 June 2009
PDF: 8 pages
Proc. SPIE 7389, Optical Measurement Systems for Industrial Inspection VI, 738927 (17 June 2009); doi: 10.1117/12.824663
Show Author Affiliations
Pengfei Zhang, Xi'an Jiaotong Univ. (China)
Hong Zhao, Xi'an Jiaotong Univ. (China)
Tao Jiang, Xi'an Jiaotong Univ. (China)
Jinjun Li, Xi'an Jiaotong Univ. (China)
Xiang Zhou, Xi'an Jiaotong Univ. (China)
Lu Zhang, Xi'an Jiaotong Univ. (China)


Published in SPIE Proceedings Vol. 7389:
Optical Measurement Systems for Industrial Inspection VI
Peter H. Lehmann, Editor(s)

© SPIE. Terms of Use
Back to Top