Share Email Print
cover

Proceedings Paper

Simulation of filling characteristics during hot embossing of polymer microstructures
Author(s): Peng Jin; Yulong Gao; Tingting Liu
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

Hot embossing is an effective way to achieve high-quality Microstructures at low cost. At present papers, the effects of geometry and shear on filling profile and polymer deformation have studied through experiments or computations. In this paper, the parameters on different polymer deformation modes: single peak, dual peak and embossing stage have researched. Especially it is referred that the mainly reasons of embossing stage phenomenon are the ratio of cavity width to height 2w/hi, the ratio of cavity width to tool width w/(w+s), and shear thinning. In addition, the temperature variation of polymer due to internal friction has discussed with evolution of imprint speed. And the simulation results prove a better coincidence with experiments.

Paper Details

Date Published: 12 January 2009
PDF: 6 pages
Proc. SPIE 7133, Fifth International Symposium on Instrumentation Science and Technology, 71334N (12 January 2009); doi: 10.1117/12.821254
Show Author Affiliations
Peng Jin, Harbin Institute of Technology (China)
Yulong Gao, Harbin Institute of Technology (China)
Tingting Liu, Harbin Institute of Technology (China)


Published in SPIE Proceedings Vol. 7133:
Fifth International Symposium on Instrumentation Science and Technology
Jiubin Tan; Xianfang Wen, Editor(s)

© SPIE. Terms of Use
Back to Top