Share Email Print
cover

Proceedings Paper

Design of x-ray waveguides for the single-mode propagation
Author(s): J. Choi; Y. Park; J. Kim
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

Single-mode propagation conditions of X-ray waveguides are investigated by numerical calculations to understand the dependence of waveguide design parameters, such as core thickness and the optical constants of waveguide materials, on the transmission and coherence properties of the waveguide. The simulation code for mode analyzing is developed based on a numerical solution of the parabolic wave equation. The initial boundary value problem is solved numerically using a finite-difference scheme based on the Crank-Nicolson scheme. The E-field intensities in a core layer are calculated at an X-ray energy of 8.0 keV for air and beryllium(Be) core waveguides with different cladding layers such as Pt, Au, W, Ni and Si to determine the dependence of waveguide materials. The highest E-field intensity radiated at the exit of the waveguide is obtained from the Pt cladded beryllium core with a thickness of 20 nm. However, the intensity from the air core waveguide with Pt cladding reaches 64% of the Be-Pt waveguide. The dependence of the core thickness, which is the major parameter used to generate a single mode in the waveguide, is investigated for the air-Pt, and Be-Pt waveguides at an X-ray energy of 8.0 keV. The mode profiles at the exit are shown for the single mode at up to a thickness of 20 nm for the air-Pt and the Be-Pt waveguides.

Paper Details

Date Published: 18 November 2008
PDF: 7 pages
Proc. SPIE 7138, Photonics, Devices, and Systems IV, 71380R (18 November 2008); doi: 10.1117/12.817991
Show Author Affiliations
J. Choi, Dankook Univ. (Korea, Republic of)
Y. Park, Dankook Univ. (Korea, Republic of)
J. Kim, Dankook Univ. (Korea, Republic of)


Published in SPIE Proceedings Vol. 7138:
Photonics, Devices, and Systems IV
Pavel Tománek; Dagmar Senderáková; Miroslav Hrabovský, Editor(s)

© SPIE. Terms of Use
Back to Top