Share Email Print
cover

Proceedings Paper

Effective purging solution to reticle haze formation
Author(s): Wei-Jui Tseng; Shean-Hwan Chiou; Ming-Chien Chiu; Po-Shin Lee
Format Member Price Non-Member Price
PDF $14.40 $18.00
cover GOOD NEWS! Your organization subscribes to the SPIE Digital Library. You may be able to download this paper for free. Check Access

Paper Abstract

The control of haze contamination on reticles has been gaining an ever-increasing focus because of its contribution to the huge yield loss in semiconductor manufacturing. Yield improvement through the reduction of haze on reticles has been a significant challenge as the use of 193nm light source and the shrinkage of line width on reticles. For a mass production IC manufacturing fab, an easy and practical solution is needed to prevent haze generation. In our previous study (Tseng et al., 2008), we demonstrated a practical and effective solution to reticle haze formation at a mass production DRAM factory. After implementing this solution, the number of wafers printed without haze development on reticles can be up to 150,000 wafers, and the maximum exposure dosage can be up to 9×108 mJ/cm2 without the detection of any printable haze. Using the average data from more than 20 reticles, the average wafer printed before cleaning of reticle was more than 100,000 wafers. This solution has been proven to be effective in reducing the generation of haze on reticles. In current study, our focus is on further improvement of this haze solution and the ultimate goal is to reduce the haze generation effectively, but also economically. First, we use ultra low outgas material, antistatic PEEK, as the material of reticle carrier to perform the study and investigate its effect on haze generation. The total outgas data, leaching, electrical field shielding, and surface resistance data of different polymer materials are also compared. Secondly, we optimize the purging flow rate to reduce the running cost, but also maintain the performance. Our approach is to design purge nozzles, which can create a smooth flow field inside reticle SMIF pod (RSP) and make the maintenance of an ultra clean RSP environment with the smallest flow rate be possible. The results show the PEEK RSP with newly designed purge nozzles can provide great haze prevention result with a lower flow rate. Detailed data is provided and compared with previous design. By using this new solution, the number of wafers printed without haze development on reticles can be up to 300,000 wafers, and the maximum exposure dosage can be up to 1.2×109 mJ/cm2 without the detection of any printable haze. The average wafer printed before cleaning of reticle was more than 170,000 wafers. This is a significant improvement to delay the generation of haze on reticles. The comparison of N2 / XCDA performance based on wafer exposure shows that no significant difference can be observed.

Paper Details

Date Published: 23 March 2009
PDF: 7 pages
Proc. SPIE 7272, Metrology, Inspection, and Process Control for Microlithography XXIII, 727226 (23 March 2009); doi: 10.1117/12.813998
Show Author Affiliations
Wei-Jui Tseng, Rexchip Electronics Corp. (Taiwan)
Shean-Hwan Chiou, Rexchip Electronics Corp. (Taiwan)
Ming-Chien Chiu, Gudeng Precision Industrial Co., Ltd. (Taiwan)
Po-Shin Lee, Gudeng Precision Industrial Co., Ltd. (Taiwan)


Published in SPIE Proceedings Vol. 7272:
Metrology, Inspection, and Process Control for Microlithography XXIII
John A. Allgair; Christopher J. Raymond, Editor(s)

© SPIE. Terms of Use
Back to Top