Share Email Print
cover

Proceedings Paper

One-step surface modification of poly(dimethylsiloxane) by undecylenic acid
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

Poly(dimethylsiloxane) (PDMS) is a popular material for microfluidic devices due to its relatively low cost, ease of fabrication, oxygen permeability and optical transmission characteristics. However, its highly hydrophobic surface is still the main factor limiting its wide application, in particular as a material for biointerfaces. A simple and rapid method to form a relatively stable hydrophilised PDMS surface is reported in this paper. The PDMS surface was treated with pure undecylenic acid (UDA) for 10 min, 1 h and 1 day at 80 °C in a sealed container. The effects of the surface modification were investigated using water contact angle (WCA) measurements, Fourier transform infrared spectroscopy in attenuated total reflection mode (FTIR-ATR), and streaming zeta-potential analysis. The water contact angle of 1 day UDAmodified PDMS was found to decrease from that of native PDMS (110 °) to 75 °, demonstrating an increase in wettability of the surface. A distinctive peak at 1715 cm-1 in the FTIR-ATR spectra after UDA treatment was representative of carboxylation of the PDMS surface. The measured zeta-potential (ζ) at pH 4 changed from -27 mV for pure PDMS to -19 mV after UDA treatment. In order to confirm carboxylation of the surface visually, Lucifer Yellow CH fluorescence dye was reacted via a condensation reaction to the 1 day UDA modified PDMS surface. Fluorescent microscopy showed Lucifer Yellow CH fluorescence on the carboxylated surface, but not on the pure PDMS surface. Stability experiments were also performed showing that 1 day modified UDA samples were stable in both MilliQ water at 50 °C for 17 h, and in a desiccator at room temperature for 19.5 h.

Paper Details

Date Published: 30 December 2008
PDF: 10 pages
Proc. SPIE 7267, Smart Materials V, 726719 (30 December 2008); doi: 10.1117/12.810101
Show Author Affiliations
Jinwen Zhou, Flinders Univ. (Australia)
Steven J. P. McInnes, Flinders Univ. (Australia)
Abdul Mutalib Md Jani, Flinders Univ. (Australia)
Amanda V Ellis, Flinders Univ. (Australia)
Nicolas H. Voelcker, Flinders Univ. (Australia)


Published in SPIE Proceedings Vol. 7267:
Smart Materials V
Nicolas H. Voelcker; Helmut W. Thissen, Editor(s)

© SPIE. Terms of Use
Back to Top