Share Email Print
cover

Proceedings Paper

Controlling macro and micro surface topography for a 45nm copper CMP process using a high resolution profiler
Author(s): Thomas Ortleb; Gerd Marxsen; Jens Heinrich; Jeff Reichert; Ronny Haupt; Petrie Yam
Format Member Price Non-Member Price
PDF $14.40 $18.00
cover GOOD NEWS! Your organization subscribes to the SPIE Digital Library. You may be able to download this paper for free. Check Access

Paper Abstract

Challenges in back-end-of-line process flow are becoming more critical as the 65 and 45 nm process control requirements become more stringent. Unoptimized copper CMP processing contributes to a significant portion of yield losses downstream, if electrical device performance does not address the technology node targets. Adequate metrology is required to meet the challenge of consistent wafer uniformity control in removing the excess copper on 300 mm wafers while preserving the material interface dielectrics at sub-nanometer levels. Dishing of the metal lines, which show the predictive nature of isolated in-die metal line loss, and erosion of the dielectric oxide across multiple oxide-metal line arrays are two key parameters indicative of the planarization process. As feature sizes continue to shrink, micro-dishing and edge-over-erosion become important to characterize and control. For process development, the knowledge of the macro and micro planarity will be increasingly essential to preventing lithography depth of focus issues. In manufacturing, the need for CMP process stability increases as a process excursion could occur at any time. In-line monitoring of macro and micro-level surface topography, dishing, erosion, micro-dishing, and edge-over-erosion parameter values allows fine tuning, optimization, and process control.

Paper Details

Date Published: 24 March 2008
PDF: 11 pages
Proc. SPIE 6922, Metrology, Inspection, and Process Control for Microlithography XXII, 69222Y (24 March 2008); doi: 10.1117/12.772951
Show Author Affiliations
Thomas Ortleb, AMD LLC and Co. KG (Germany)
Gerd Marxsen, AMD LLC and Co. KG (Germany)
Jens Heinrich, AMD LLC and Co. KG (Germany)
Jeff Reichert, KLA-Tencor (United States)
Ronny Haupt, KLA-Tencor (United States)
Petrie Yam, KLA-Tencor (United States)


Published in SPIE Proceedings Vol. 6922:
Metrology, Inspection, and Process Control for Microlithography XXII
John A. Allgair; Christopher J. Raymond, Editor(s)

© SPIE. Terms of Use
Back to Top