Share Email Print

Proceedings Paper

Design requirements for a stand alone EUV interferometer
Author(s): Ph. Michallon; C. Constancias; A. Lagrange; B. Dalzotto
Format Member Price Non-Member Price
PDF $14.40 $18.00
cover GOOD NEWS! Your organization subscribes to the SPIE Digital Library. You may be able to download this paper for free. Check Access

Paper Abstract

EUV lithography is expected to be inserted for the 32/22 nm nodes with possible extension below. EUV resist availability remains one of the main issues to be resolved. There is an urgent need to provide suitable tools to accelerate resist development and to achieve resolution, LER and sensitivity specifications simultaneously. An interferometer lithography tool offers advantages regarding conventional EUV exposure tool. It allows the evaluation of resists, free from the deficiencies of optics and mask which are limiting the achieved resolution. Traditionally, a dedicated beam line from a synchrotron, with limited access, is used as a light source in EUV interference lithography. This paper identifies the technology locks to develop a stand alone EUV interferometer using a compact EUV source. It will describe the theoretical solutions adopted and especially look at the feasibility according to available technologies. EUV sources available on the market have been evaluated in terms of power level, source size, spatial coherency, dose uniformity, accuracy, stability and reproducibility. According to the EUV source characteristics, several optic designs were studied (simple or double gratings). For each of these solutions, the source and collimation optic specifications have been determined. To reduce the exposure time, a new grating technology will also be presented allowing to significantly increasing the transmission system efficiency. The optical grating designs were studied to allow multi-pitch resolution print on the same exposure without any focus adjustment. Finally micro mechanical system supporting the gratings was studied integrating the issues due to vacuum environment, alignment capability, motion precision, automation and metrology to ensure the needed placement control between gratings and wafer. A similar study was carried out for the collimation-optics mechanical support which depends on the source characteristics.

Paper Details

Date Published: 21 March 2008
PDF: 9 pages
Proc. SPIE 6921, Emerging Lithographic Technologies XII, 69213Y (21 March 2008); doi: 10.1117/12.771586
Show Author Affiliations
Ph. Michallon, CEA-LETI, MINATEC (France)
C. Constancias, CEA-LETI, MINATEC (France)
A. Lagrange, CEA-LETI, MINATEC (France)
B. Dalzotto, CEA-LETI, MINATEC (France)

Published in SPIE Proceedings Vol. 6921:
Emerging Lithographic Technologies XII
Frank M. Schellenberg, Editor(s)

© SPIE. Terms of Use
Back to Top