Share Email Print
cover

Proceedings Paper

Characterization of novel optical fibers for use in laser detonators
Author(s): M. D. Bowden; R. C. Drake; C. A. Singleton
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

A system for launching flyers using a Q-switched Nd: YAG laser has been developed for shock initiation of secondary explosives. Flyers have been launched at velocities approaching 6 km s-1. Optical fibers are used to transport the optical energy from the laser to the detonator. The launch of these flyers with sufficient velocity requires a fluence in the region of 35 J cm-2, significantly above the damage threshold of most optical fibers. This damage is typically caused by laser absorption at the input face due to imperfections in the surface polishing. A variety of optical fibers with high quality input faces have been tested at fluences up to 50 J cm-2, and their damage thresholds and beam profiles have been measured. The standard fiber used in this system is a low hydroxyl (-OH) content, 400μm diameter core silica fiber, with CO2 laser polished faces. In addition to this, fibers tapering down to 300μm and 200μm core diameter were investigated, as a means of increasing the efficiency of the system, along with mechanically polished fibers. The fiber currently enters the detonator body from the rear. Depending on the application, it may be required for the fiber to enter from the side. To facilitate this, fibers with a machined output face, designed to produce an output at approximately 90 degrees to the fiber axis were tested. Finally, a 2:1 fiber splitter was tested, as a first step to enable simultaneous firing of several detonators. Multiple initiation points are desirable for applications such as programmable initiation, and it is intended to study fiber splitters with a higher split ratio, such as 4:1 and 8:1. The results of these experiments are presented, and assessments made of suitability for transmission of high-power Qswitched Nd:YAG laser pulses.

Paper Details

Date Published: 1 September 2006
PDF: 14 pages
Proc. SPIE 6287, Optical Technologies for Arming, Safing, Fuzing, and Firing II, 628701 (1 September 2006); doi: 10.1117/12.680803
Show Author Affiliations
M. D. Bowden, Atomic Weapons Establishment (United Kingdom)
R. C. Drake, Atomic Weapons Establishment (United Kingdom)
C. A. Singleton, Atomic Weapons Establishment (United Kingdom)


Published in SPIE Proceedings Vol. 6287:
Optical Technologies for Arming, Safing, Fuzing, and Firing II
William J. Thomes; Fred M. Dickey, Editor(s)

© SPIE. Terms of Use
Back to Top