Share Email Print

Proceedings Paper

Measurement of drill grinding parameters using laser sensor
Author(s): Peng Yanping; Hiroyuki Kumehara; Zhang Wei; Takashi Nomura
Format Member Price Non-Member Price
PDF $14.40 $18.00
cover GOOD NEWS! Your organization subscribes to the SPIE Digital Library. You may be able to download this paper for free. Check Access

Paper Abstract

To measure the grinding parameters and geometry parameters accurately for a drill point is essential to its design and reconditioning. In recent years, a number of non-contact coordinate measuring apparatuses, using CCD camera or laser sensors, are developed. But, a lot work is to be done for further improvement. This paper reports another kind of laser coordinate meter. As an example of its application, the method for geometry inspection of the drill flank surface is detailed. Measured data from laser scanning on the flank surface around some points with several 2-dimensional curves are analyzed with mathematical procedure. If one of these curves turns to be a straight line, it must be the generatrix of the grinding cone. Thus, the grinding parameters are determined by a set of three generatrices. Then, the measurement method and data processing procedure are proposed. Its validity is assessed by measuring a sample with given parameters. The point geometry measured agrees well with the known values. In comparison with other methods in the published literature, it is simpler in computation and more accurate in results.

Paper Details

Date Published: 9 December 2005
PDF: 7 pages
Proc. SPIE 6024, ICO20: Optical Devices and Instruments, 602418 (9 December 2005); doi: 10.1117/12.666852
Show Author Affiliations
Peng Yanping, Gunma Univ. (Japan)
Hiroyuki Kumehara, Gunma Univ. (Japan)
Zhang Wei, Dalian Institute of Light Industry (China)
Takashi Nomura, Keyence Corp. (Japan)

Published in SPIE Proceedings Vol. 6024:
ICO20: Optical Devices and Instruments
James C. Wyant; X. J. Zhang, Editor(s)

© SPIE. Terms of Use
Back to Top