Share Email Print
cover

Proceedings Paper

Study of machining process computer simulation of a NC-WEDM-HS system of two turning coordinates
Author(s): Fujun Ren; Dechen Huang; Jinchun Liu
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

In order to raise the productivity and precision of Numeric Control-Wire Cut Electric Discharge Machining with High Speed (NC-WEDM-HS) system of two turning coordinates, the basic idea of simulation of the machining process of this machining system was introduced. The characteristics and general laws of cutting complex curved surfaces by the NC-WEDM-HS system of two turning coordinates were systematically analyzed. The motion parameters and motion forms of the NC-WEDM-HS system of two turning coordinates were also analyzed. The universal mathematical models of the NC-WEDM-HS system of two turning coordinates were derived. Many simulating programs were designed. Experiments on cutting complex curved surface by the NC-WEDM-HS system of two turning coordinates were conducted and many complex curved surface parts were machined. Good simulation results were obtained. Expected results were achieved. The application of this simulating technology was depicted. All these works provide an effective approach to resolve the problems of cutting complex curved surface parts by the mathematical models of the NC-WEDM-HS system.

Paper Details

Date Published: 2 May 2006
PDF: 6 pages
Proc. SPIE 6042, ICMIT 2005: Control Systems and Robotics, 604246 (2 May 2006); doi: 10.1117/12.664798
Show Author Affiliations
Fujun Ren, Harbin Univ. of Science and Technology (China)
Jiamusi Univ. (China)
Dechen Huang, Jiamusi Univ. (China)
Jinchun Liu, Harbin Institute of Technology (China)


Published in SPIE Proceedings Vol. 6042:
ICMIT 2005: Control Systems and Robotics

© SPIE. Terms of Use
Back to Top