Share Email Print
cover

Proceedings Paper

Design-friendly DFM rule
Author(s): Morimi Osawa; Takayoshi Minami; Hiroki Futatsuya; Satoru Asai
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

We proposed a design-friendly DFM rule intended to improve circuit performance. To reduce variations in the gate length, we applied active usage of preferred gate spaces and optimized the lithographic conditions. We selected the spaces to take into account the layouts that are used most frequently in actual design, so that many designers who are worrying about chip area and performance can follow the rule. The effect of our method was evaluated for 65-nm node technology. From the viewpoint of gate length, parallel usage of design following the rule and optimization lead to an 8% decrease in variation, and a 38% decrease in the mean difference from the targeted gate length. We also evaluated the effect on delays using an accurate method that can treat both statistical and systematic variation. The difference in the average delay from the targeted value was reduced from about 1% to less than 0.1%, and a 10% improvement in delay variation was observed.

Paper Details

Date Published: 13 March 2006
PDF: 9 pages
Proc. SPIE 6156, Design and Process Integration for Microelectronic Manufacturing IV, 61560G (13 March 2006); doi: 10.1117/12.656271
Show Author Affiliations
Morimi Osawa, Fujitsu Ltd. (Japan)
Takayoshi Minami, Fujitsu Ltd. (Japan)
Hiroki Futatsuya, Fujitsu Ltd. (Japan)
Satoru Asai, Fujitsu Ltd. (Japan)


Published in SPIE Proceedings Vol. 6156:
Design and Process Integration for Microelectronic Manufacturing IV
Alfred K. K. Wong; Vivek K. Singh, Editor(s)

© SPIE. Terms of Use
Back to Top