Share Email Print
cover

Proceedings Paper

Correcting lens distortion in 3D measuring systems using fringe projection
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

In this paper several techniques are described to perform the determination and correction of lens distortion in fringe projection systems for 3D object measurement. A new method to realise distortion determination for projection systems is introduced. It uses a plane surface and the projected fringe pattern as calibration tools and determines simultaneously the distortion of both projector and camera lens within an iterative procedure. The lens distortion calibration is performed in the state of the device "ready for measurement" which avoids errors by a later adjustment. A reduction of distortion errors up to 0.02 pixels in the projector chip and also in the camera chip is possible and leads to considerable improvements in the 3D measurements.

Paper Details

Date Published: 15 October 2005
PDF: 11 pages
Proc. SPIE 5962, Optical Design and Engineering II, 59620J (15 October 2005); doi: 10.1117/12.624821
Show Author Affiliations
Christian Bräuer-Burchardt, Fraunhofer IOF Jena (Germany)


Published in SPIE Proceedings Vol. 5962:
Optical Design and Engineering II
Laurent Mazuray; Rolf Wartmann, Editor(s)

© SPIE. Terms of Use
Back to Top