Share Email Print
cover

Proceedings Paper

Deep proton lithography outside the vacuum setup
Author(s): Rafal Kasztelanic
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

There are several technologies for cheap mass fabrication of microelements. When we need elements of high structural depth, one of the most important technologies is the LIGA process. Since this method is time- and cost-consuming, there are a few alternative methods to be used instead of the LIGA. One of them is the use of the ion track lithography, especially deep proton lithography. So far, all the deep lithography setups have operated in vacuum. Accelerated protons were focused or formed by a mask to light a target placed in vacuum. Such an approach limited the size of the target and lengthened the time needed to place a new the target in the setup. It also needed a relatively small steering setup, adapted to operate in vacuum. That is why a novel proton lithography setup operating in the air has been proposed. The setup, whose size is no longer limited, allows for a quick access to the target. However, the parameters of the proton beam moving from vacuum into the air change, which affects the way protons interact with the target. This enforces adding several new elements to the classical proton lithography setup. In spite of that, such a setup is cheaper and easier to use than the classical one, but it allows for obtaining microelements of similar quality.

Paper Details

Date Published: 6 October 2005
PDF: 8 pages
Proc. SPIE 5948, Photonics Applications in Industry and Research IV, 59481F (6 October 2005); doi: 10.1117/12.623218
Show Author Affiliations
Rafal Kasztelanic, Warsaw Univ. (Poland)


Published in SPIE Proceedings Vol. 5948:
Photonics Applications in Industry and Research IV
Ryszard S. Romaniuk; Stefan Simrock; Vladimir M. Lutkovski, Editor(s)

© SPIE. Terms of Use
Back to Top