Share Email Print
cover

Proceedings Paper

Impedance based flow sensor
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

Microfluidic analysis devices, often referred to as Micro Total Analysis Systems or the Lab-on-a-chip, are often based on the manipulation of small volumes of fluid. These devices require the design and fabrication of components for fluid handling, control and measurement, such as micropumps, micromixers and flow sensors. The fabrication of miniature versions of large scale components such as pressure sensors and flow rate meters has been demonstrated. However, complicated fabrication is prohibitive and devices which involve flow constriction can be prone to blocking if particle containing samples are used. This paper presents results of the design and fabrication of a microimpedance measurement cell, designed to measure the impedance of sub-nanolitre volumes of fluids. The measurement system was designed to measure the electrical impedance at several different frequencies, allowing identification and analysis of the material contained within the sample volume. Measurements of different fluids at different flow rates through a microchannel containing the measurement cell are presented. The use of this system as a solid state flow rate sensor is then discussed.

Paper Details

Date Published: 1 July 2005
PDF: 8 pages
Proc. SPIE 5836, Smart Sensors, Actuators, and MEMS II, (1 July 2005); doi: 10.1117/12.608825
Show Author Affiliations
Nicolas G. Green, Univ. of Southampton (United Kingdom)
Sun Tao, Univ. of Southampton (United Kingdom)
David Holmes, Univ. of Southampton (United Kingdom)
Hywel Morgan, Univ. of Southampton (United Kingdom)


Published in SPIE Proceedings Vol. 5836:
Smart Sensors, Actuators, and MEMS II
Carles Cane; Jung-Chih Chiao; Fernando Vidal Verdu, Editor(s)

© SPIE. Terms of Use
Back to Top