Share Email Print
cover

Proceedings Paper

Analysis and testing of a THUNDER piezoelectric actuator as a prime mover in a gas flow control valve
Author(s): Jesse C. Rodgers; William W. Clark; Jeffrey S. Vipperman
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

This paper presents an experimental analysis in which a THUNDER (Thin Unimorph DrivER) actuator was used to adjust the flow of air through a specified cross sectional area inside a Plexiglas housing. The THUNDER is a curved, bilayer actuator made up of a piezoelectric layer and a stainless steel layer. In this work the THUNDER is used as the prime mover in an air flow control valve. The valve is made up of a flow channel that allows air to pass over the top of the actuator. When voltage is applied to the actuator, the piezoceramic layer expands or contracts, changing the actuator’s curvature, thus changing the orifice area in the valve resulting in a change in flow. Testing is done with single and dual flow loop arrangements. In the dual flow loop, one flow line contains the control valve while the other is a bypass line. The valve is used to balance flow between the lines. Both lines have adjustable outlet valves so that the valve can be tested under a wide range of flow conditions. Several lids for the control valve were manufactured and tested to reveal the possibility of increase modulation performance using alternative channel geometries. The test results showed that the THUNDER control valve could modulate the air flow by as much as 16% at 4.4 SCFM (125 LPM) in single loop flow and 30% at 2.3 SCFM (65 LPM) in dual loop flow for inlet pressures up to 25 PSI (172 kPa).

Paper Details

Date Published: 17 May 2005
PDF: 12 pages
Proc. SPIE 5764, Smart Structures and Materials 2005: Smart Structures and Integrated Systems, (17 May 2005); doi: 10.1117/12.599624
Show Author Affiliations
Jesse C. Rodgers, Univ. of Pittsburgh (United States)
William W. Clark, Univ. of Pittsburgh (United States)
Jeffrey S. Vipperman, Univ. of Pittsburgh (United States)


Published in SPIE Proceedings Vol. 5764:
Smart Structures and Materials 2005: Smart Structures and Integrated Systems
Alison B. Flatau, Editor(s)

© SPIE. Terms of Use
Back to Top