Share Email Print
cover

Proceedings Paper

Dual side lithography measurement, precision, and accuracy
Author(s): Daniel Schurz; Warren W. Flack; Robert L. Hsieh
Format Member Price Non-Member Price
PDF $14.40 $18.00

Paper Abstract

Advances in micromachining (MEMS) applications such as optical components, inertial and pressure sensors, fluidic pumps and radio frequency (RF) devices are driving lithographic requirements for tighter registration, improved pattern resolution, and improved process control for pattern placement on both sides of the substrate. Consequently, there is a similar increase in demand for advanced metrology tools capable of measuring the Dual Side Alignment (DSA) performance of lithographic systems. The requirements for an advanced DSA metrology tool include the capability of measuring points over the entire area of the substrate, and of measuring a variety of different substrates and film types and thicknesses. This paper discusses the precision and accuracy of an advanced DSA metrology system, the UltraMet 100. This system offers DSA registration measurement at greater than 90% of a wafer's surface area, providing a complete front to back side registration evaluation across a wafer. The system uses top and bottom cameras and a pattern recognition system that allow simultaneous target capture and measurement on both substrate surfaces. Because no industry standard has been established to determine the accuracy of dual side pattern metrology, an accuracy gauge was designed for this study that allows both top and bottom cameras to simultaneously measure offsets between two targets on one substrate surface. In this paper, an accuracy gauge is measured on the UltraMet 100 and the results are compared to measurements taken on a reticle X/Y pattern placement metrology tool calibrated to a NIST traceable standard. In addition, tool performance is analyzed in terms of system repeatability and reproducibility.

Paper Details

Date Published: 10 May 2005
PDF: 8 pages
Proc. SPIE 5752, Metrology, Inspection, and Process Control for Microlithography XIX, (10 May 2005); doi: 10.1117/12.598861
Show Author Affiliations
Daniel Schurz, Ultratech, Inc. (United States)
Warren W. Flack, Ultratech, Inc. (United States)
Robert L. Hsieh, Ultratech, Inc. (United States)


Published in SPIE Proceedings Vol. 5752:
Metrology, Inspection, and Process Control for Microlithography XIX
Richard M. Silver, Editor(s)

© SPIE. Terms of Use
Back to Top