Share Email Print
cover

Proceedings Paper

Novel high-Q torsion microresonator
Author(s): Prakash R. Apte; Anand Gawarikar; G. Ajishna; Sanjib K. Sahoo
Format Member Price Non-Member Price
PDF $14.40 $18.00
cover GOOD NEWS! Your organization subscribes to the SPIE Digital Library. You may be able to download this paper for free. Check Access

Paper Abstract

In this paper, we propose a resonator structure with a high Q factor, which has the potential to replace the Quartz crystal. In order to achieve a higher Q, complete decoupling of the resonating structure from the supporting ends is desired. One of the ways of achieving this is to distribute the stress uniformly throughout the support beam rather than their being concentrated at the fixed ends. This suggests a resonating mass supported by torsion wires. Here, three resonating structures are connected in a serial fashion. The outer two resonators act as interfaces to the external oscillator circuit, while the centre one is fully decoupled. The losses at the end of torsion wires are thus kept to lowest value. The other losses, namely damping and internal friction losses, are kept to a minimum by providing vacuum and using high quality material for the torsion wire. Modal analysis and static stress analysis were done on the structures and results clearly show the fundamental torsion mode of vibration and extremely small stresses at the fixed ends of the torsion wire.

Paper Details

Date Published: 22 January 2005
PDF: 8 pages
Proc. SPIE 5717, MEMS/MOEMS Components and Their Applications II, (22 January 2005); doi: 10.1117/12.590016
Show Author Affiliations
Prakash R. Apte, Indian Institute of Technology Bombay (India)
Anand Gawarikar, Banaras Hindu Univ. (India)
G. Ajishna, Indian Institute of Technology (India)
Sanjib K. Sahoo, Indian Institute of Technology Bombay (India)


Published in SPIE Proceedings Vol. 5717:
MEMS/MOEMS Components and Their Applications II
Albert K. Henning, Editor(s)

© SPIE. Terms of Use
Back to Top