Share Email Print

Proceedings Paper

Efficiency of vaporization cutting by copper vapor laser
Author(s): Michail O. Nikonchuk; Igor V. Polyakov
Format Member Price Non-Member Price
PDF $17.00 $21.00

Paper Abstract

The copper vapor laser (CVL) can be a very suitable tool for cutting and drilling with minimum roughness and maximum accuracy. Visible range of irradiation, perfect quality of output beam, high pulse power, and pulse repetition frequency favor this application. However, there is no data on productivity of cutting, which defines the economic benefit of using CVL technology. In the present paper, the cutting productivity is estimated on the basis of efficiency of material removal from the processing zone: the ratio of evaporated mass (multiplied by vaporization heat) to laser energy within the processing time. Aluminum specimens with 0.02 (mu) thickness (thin film) and 100 (mu) thickness (foil) are cut with different output power and cutting velocity. Use of specimens with these thicknesses allows the observation of two phenomena which define the cutting efficiency. One of them, evaporation from the free surface, is typical for thin (a few micron or less) materials. The second one, vapor flying and condensation, can only reduce initial efficiency when material thickness becomes more than cutwidth.

Paper Details

Date Published: 1 May 1992
PDF: 4 pages
Proc. SPIE 1628, Intense Laser Beams, (1 May 1992); doi: 10.1117/12.59001
Show Author Affiliations
Michail O. Nikonchuk, St. Petersburg Technical Univ. (Russia)
Igor V. Polyakov, St. Petersburg Technical Univ. (Russia)

Published in SPIE Proceedings Vol. 1628:
Intense Laser Beams
Richard C. Wade; Peter B. Ulrich, Editor(s)

© SPIE. Terms of Use
Back to Top